In case of ground vibrations or position changes during operation, the tool is automatically leveled in again. To avoid errors, check the position of the horizontal and vertical laser line with regard to the reference points upon re-leveling.
Operating Modes Fig.1
The tool has four operating modes between which you can switch at any time with the on/off switch 1:
–1 Horizontal laser line: The tool generates a horizontal laser line running side to side.
–2 Vertical laser line: The tool generates a vertical laser line running upward and downward.
–3 Laser cross line: The tool generates two laser lines one horizontal and one vertical that cross. The laser lines cross each other at a 90° angle.
–4 Manual Mode: The tool generates a horizontal laser line with the compensator locked. When the compensator is locked the tool can be used on a tilt that exceeds 4°.
–5 OFF:
LED indicator
A- LED Illuminates green when unit is ON
B- LED illuminates red in Manual Mode
C-LED illuminates red and lasers blink when out of leveling range.
Working Advice
•Always use the center of the laser line for marking. The width of the laser line changes with the distance.
Use with Accessories
Working with the Tripod
A tripod offers a stable, height-adjustable measuring support. Place the tool via the tripod mount 5 onto the 1/4-20 male thread of the tripod and screw the locking screw of the tripod tight.