SUPPLY | BLACK AND BLUE | NOTE: CEILING COVER |
GROUND | FAN WIRES | OMITTED FOR CLARITY. |
WIRE |
|
|
LISTED |
| WHITE SUPPLY |
WIRE |
| |
CONNECTOR (3) |
| (NEUTRAL) |
GREEN WIRE |
|
|
(GROUND) FROM |
| WHITE FAN |
HANGER BRACKET |
| WIRE |
GREEN WIRE |
| BLACK SUPPLY (HOT) |
(GROUND) FROM |
| |
HANGER BALL | THREADED | |
Figure 12 |
| STUD (2) |
!WARNING
Check to see that all connections are tight, including ground, and that no bare wire is visible at the wire connectors, except for the ground wire. Do not operate fan until blades are in place. Noise and fan damage could result.
3.Screw the two threaded studs (supplied) into the tapped holes in the hanger bracket (Figure 12).
4.Lift the ceiling cover up to the threaded studs and turn until studs protrude through the holes in the ceiling cover (Figure 13).
5.Secure the ceiling cover in place by sliding lockwashers over the threaded studs and installing the two knurled knobs (supplied). (Figure 13.) Tighten the knurled knobs securely until the ceiling cover fits snugly against the ceiling and the hole in the ceiling cover is clear of the downrod. Your fan is now wired to be turned on and off from the fan switch.
Using Your Ceiling Fan
1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.
2.Check the operation of the fan by gently pulling on the pull chain switch.
3.All fans are shipped from the factory with the reversing switch positioned to circulate air down- ward. If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then pull on the reversing control pull chain and turn fan on again. The fan blades will turn in the opposite direction and reverse the airflow.
Your fan model is equipped with a 
|
|
1st |
|
2nd |
|
3rd | REVERSING |
4th | CONTROL |
PULL CHAIN | |
| SPEED CONTROL |
| SWITCH PULL CHAIN |
Maintenance
IMPORTANT CARE INSTRUCTIONS
for your Ceiling Fan
Periodic cleaning of your new ceiling fan is the only maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to avoid scratching the finish.
Abrasive cleaning agents are not required and should be avoided to prevent damage to finish.
CEILING COVER
LOCKWASHER | THREADED |
KNURLED KNOB | STUD |
|
Figure 13
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are completely inside the outlet box and not pinched between the ceiling cover and the ceiling.
6.The longer pull chain is on the speed control switch; the shorter chain is on the reversing switch. Install the large wood pendant (supplied) on the longer pull chain by sliding the pendant (small hole first) onto the pull chain; then attach the chain coupler (supplied) to the end of the chain and allow the pendant to fall down over the coupling. Install the small wood pendant (supplied) on the shorter pull chain in the same manner.
7
!WARNING
Do not use water when cleaning your ceiling fan. It could damage the motor or the blades and create the possibility of an electrical shock.
Accessories
1.Ceiling Fan Light Kits (see store or catalog).
2.Ceiling Fan/Light Controls (see store or catalog).
3.Downrod Extension Kits (see store or catalog).
!WARNING
The use of any other control not specifically approved for this fan could result in fire, shock and personal injury.
!WARNING
This product is designed to use only those parts supplied with this product and/or any accessories designated specifically for use with this product by Emerson Company. Substitution of parts or accessories not designated for use with this product by Emerson Company could result in personal injury or property damage.