Epson 36-075 instruction manual Unpacking, Assembly Instructions, Assembling Table Lock Handle

Page 4

UNPACKING

1.Remove the miter saw and all loose items from the carton. IMPORTANT: DO NOT LIFT THE MITER SAW

BY THE SWITCH HANDLE AS THIS MAY CAUSE MISALIGNMENT. ALWAYS LIFT THE MACHINE BY THE BASE OR CARRYING HANDLE. Fig. 2 illustrates the machine and all loose items after they have been removed from the carton.

1 - Miter Saw

2 - Dust Bag

3 - Wrenches for changing the blade

4 - Table lock handle

1

2

4

 

3

Fig. 2

ASSEMBLY INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MITER SAW TO THE POWER SOURCE UNTIL THE MACHINE IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE ENTIRE OWNER’S MANUAL.

ASSEMBLING TABLE LOCK HANDLE

1.Thread table lock handle (A) Fig. 3, into the threaded hole (B) of the arm bracket (C).

2.Figure 4, illustrates the table lock handle (A) assem- bled to the saw.

ROTATING TABLE TO 90 DEGREE POSITION

1.Loosen table lock handle (A) Fig. 4, one or two turns and depress index lever (B) to release 45 degree positive stop.

2.Rotate table to the left until index stop engages with the 90 degree positive stop as shown in Fig. 5. Then tighten table lock handle (A).

A

C B

Fig. 3

B

A

A

Fig. 4

Fig. 5

4

Image 4
Contents Compound Power Miter Saw Safety Rules Always Wear EYE ProtectionAdditional Safety Rules for Miter Saws Assembly Instructions UnpackingAssembling Table Lock Handle Rotating Table to 90 Degree PositionMoving Cuttinghead to the UP Position Fastening Machine to Supporting SurfaceAssembling Dust BAG Connecting SAW to Power Source Power ConnectionsExtension Cords Minimum Gauge Extension CordOperating Controls and Adjustments Locking Switch OFF PositionTable Hazard Area Starting Stopping MachineRotating Table for Miter Cutting Adjusting PointerPointer and Scale Tilting Cuttinghead for Bevel Cutting Rear SUPPORT/CARRYING HandleAdjusting Fence Degrees to Blade Adjusting Downward Travel of SAW BladeAdjusting 90 Degree Bevel Stops Adjusting Tension Cuttinghead Return SpringTypical Operations and Helpful Hints Locking Cuttinghead in the Down PositionAuxiliary Wood Fence General Cutting OperationsCutting Aluminum Cutting Bowed MaterialCutting Crown Moulding Piece of crown moulding used for the insideMaintenance Changing the BladeBrush Inspection Replacement Page PARTS, Service or Warranty Assistance PORTER-CABLE Delta Service Centers