DEPTH OF CUT ADJUSTMENTS
See Figures 4, 5, and 6.
We recommend that cuts be made at a depth not exceeding 1/8 in. and that several passes be made to reach depths of
cut greater than 1/8 in.
•UNPLUG YOUR ROUTER,
[ ,WARNING:
Failure to unplug your router could result in accidental I starting causing serious injury.
•Place your router on a flat surface, loosen locking knob, and turn depth adjusting ring until cutter is inside subbase. See Figure 4.
•Turn depth adjusting ring until tip of cutter touches flat surface. Turn the depth indicator ring until the zero lines up with the indicator point on the base. NOTE: The depth indicator ring is also a zero reset indicator when setting cutter at zero depth of cut, then it becomes the depth adjusting ring. See Figure 5.
•Position your router so _at the cutter can extend below the subbase for desired depth setting. See Figure 6.
•Turn the depth adjusting ring to obtain the desired depth of cut. The distance the cutter moves can be read on the
depth indicator ring, Each mark on the depth indicator ring indicates 1/16 inch change in depth setting. Indicator point is located on the base.
•Tighten locking knob securely before operating router.
| DEPTH |
|
| ADJUSTINGRING | |
| DEPTH |
|
| INDICATORRING | |
| INDICATOR |
|
CUTTER |
|
|
INSIDE SUBBASE | 'SUBBASE | Fig. 4 |
i |
| i |
CUTTERAT ZERO
DEPTHOF CUT
Fig. 5
Page 11