•TIME: To select a charging time, you must be in the MANUAL mode and have selected a charge rate. Touch the TIME pad until the desired time shows on the meter. The following chart shows the amount of time available for each charge rate and the amount of time, in hours, added for each touch of the TIME pad.
RATE | 2 Amps | 20 Amps | 60 Amps |
Maximum | 18 Hours | 10 Hours | 5 Hours |
Time |
|
|
|
|
|
|
|
Increment | 1 Hour | 1 Hour | 1/2 Hour |
Settings |
|
|
|
|
|
|
|
If you do not set a time, the charger will run for the maximum time. After selecting the charge rate and proper time, the charger will start charging after a short delay. To see how much time remains during the charging process, touch the TIME pad.
•RESET: To stop charging or to change settings once charging has begun, touch the RESET pad. Then proceed as if you’ve just turned on the charger.
•VOLT/AMP: When the charger is turned on the METER will display battery voltage. Touch the VOLTS/AMPS pad to display the charge rate in amps.
•TESTER: To check the battery’s
•ENGINE START: To use the starter feature to help crank the engine of your vehicle, touch RESET, MANUAL, and ENGINE START - in that order. Wait for the display to show RDY. The ENGINE START feature will deliver 275 amps to help crank a
CAUTION: DO NOT try to crank an engine without a battery installed. You may damage the vehicle’s electrical system.
1 HR | 2 HR | 3 HR |
PRESS | PRESS | PRESS |
ONE TIME | TWO TIMES | THREE TIMES |
TOUCH "TIME" PAD TO ADD INCREMENTS
OFF SWITCH ON
POWER
6V SWITCH 12V
BATTERY
8