Before Using Your Battery Charger

It is important to prepare your charger for use. This section will tell you how to assemble the charger, ground and connect the power cord, and prepare to charge a battery.

Assembling your charger

It is important to fully assemble your charger before use.

Follow these instructions for easy assembly.

PARTS:	TOOLS NEEDED:

Two, 10-32 thread cutting	3/8" wrench
screws	(for mounting foot)
Two, 1/4-20 thread cutting	5/16" wrench
screws	(for wheels)
Two wheels	Hammer
One axle	Phillips screwdriver
Two axle caps
Two axle brackets
One handle
One handle grip
One mounting foot

Attach Foot:

Remove charger from packing materials and place charger on its side. Attach mounting foot and secure with the two, 1/4-20 thread cutting screws provided.

Axle Assembly:

Hold axle upright on floor or work surface. Then, using a hammer, tap one of the axle caps onto

the top end of the axle. Be sure to tap the hub on straight. Slide both wheels onto the axle with the hubs facing inward. Tap the other axle cap onto the opposite end of the axle and place the axle assembly onto the bottom of the charger.

continued on next page