ADJUSTING THE BLADE SQUARE TO TABLE
WARNING: FOR YOUR OWN SAFETY, TURN
COMBINATION
SWITCH "OFF", REMOVE KEY AND REMOVE
PLUG FROM POWER SOURCE OUTLET.
1, WITH BLADE INSTALLED AND TENSIONED
place combination square on side of blade, Guard prevents placing square directly against blade, so gauge squareness of blade to table by viewing from side of saw,,
GUARD
BLA[
SQUARE
HOUSING
2 If an adjustment is necessary, foosen four (4) hex bolts located at back of lower arm on saw using 7/16" wrench. Align blade square to table by tilting housing forward or backward, and retighten all four (4) bolts
NOTE: Make certain the blade is centered in the
insert opening Readjust if necessary by loosening four hex head bolts and moving housing to center the blade Retighten bolts
3 Place square in front of blade Guard prevents placing square directly against blade, so gauge squareness of table to blade by viewing from front of saw
4 If an adjustment is necessary, loosen bevel lock knob located under base and rotate housing
slightly to align blade to combination square Tighten bevel lock knob
HEX HEAD BOLTS
HOUSING
BEVELLOOK CO ,¢2#,ON
NOB
BLADE _
J
BEVEL LOCK KNOB
F
13