Location and function of controls

TENSION KNOB

ON/OFF SWITCH

GUARD LOCK KNOBS	BLADE	HOLDER
	RETAINING	CLIPS
GUARD	BLOWER
	TUBE	]OLDERS
		BLADE HOLDER
		POCKETS

BEVEL

SCALES

TABLEI

INSERT MITER GAUGE

BEVELLOCK KNOB

LOCK KNOB

BLADE STORAGE

motor specifications and electrical requirements

This machine is equipped with a 1725 RPM motor it is wired for operation on 110-t20 volts, 60 Hz.,

alternating current. (TOOL MUST NOT BE CONVERTED TO OPERATE ON 230 VOLT)

For replacement motor refer to parts list in this manual.

CONNECTING TO POWER SUPPLY OUTLET

If power cord is worn or'cut, or damaged in any way, have it replaced immediately

WARNING: IF NOT PROPERLY GROUNDED THIS POWER TOOL CAN CAUSE AN ELECTRICAL SHOCK PARTICULARLY WHEN USED IN DAMP

LOCATIONS CLOSE TO PLUMBING. IF AN ELECTRICAL SHOCK OCCURS THERE IS THE POTENTIAL OF A SECONDARY HAZARD SUCH

AS YOUR HANDS CONTACTING THE SAW BLADE,

If you are not sure that your outlet, as pictured below, is properly grounded, have it checked by a

qualified efectrician

Your unit is for use on 110-120volts, and hasa plug that looks like illustration below

This power tool is equipped with a 3=conductor cord and grounding type plug which has been approved by Underwriters' Laboratories and the Canadian Standards Association.. The ground conductor' has a

green jacket and is attached to the tool housing at one end and to the ground prong in the attachment

plug at the other'end

WARNING: DO NOT PERMIT FINGERS TO

TOUCH THE TERMINALS OF PLUGS WHEN INSTALLING OR REMOVING THE PLUG TO OR FROM THE OUTLET.

3-PRONG PLUG

PROPERLY

GROUNDED

OUTLET

GROUNDING PRONG

Plug power cord intoa 110-120Vproperlygrounded type outlet protected by a 15-amp dual element time delay or Circuit-Saver fuse or circuit breaker If the outlet you are planning to use for tMs power

tool is of the 2 prong type, DO NOT REMOVE OR

ALTER THE GROUNDING PRONG tN ANY MANNER Use an adapter as shown below and always connect the grounding lug to known ground

It is recommended that you have a qualified electrician replace the TWO prong outlet with a properly grounded THREE prong outlet

GROUNDING LUG

ADAPTER
	MAKE SURE THIS IS
3-PRONG	TO A
PLUG	KNOWN GROUND
	2*PRONG
	RECEPTACLE

An adapter as illustrated is available for connecting plugs to 2-prong receptacles

WARNING: THE GREEN GROUNDING LUG

EXTENDING FROM THE ADAPTER MUST BE

CONNECTED TO A PERMANENT GROUND SUCH AS TO A PROPERLY GROUNDED OUTLET BOX. NOT ALL OUTLET BOXES ARE PROPERLY GROUNDED.

If you are not sure that your outlet box is properly grounded, have it checked by a qualified electrician

NOTE: The adapter illustrated is for use only if you

already have a properly grounded 2-prong receptacle. Adapter is not allowed in Canada by the Canadian Electrical Code

The use of any extension cord will cause some loss of power. To keep this to a minimum and to prevent over-heating and motor burn-out, use the following table to determine the minimum wire size (AWG) extension cord

Use only 3 wire extension cords which have 3-prong

grounding type plugs and 3-pole receptacles which accept the tools plug

Extension Cord Length		Wire Size AWG
0-25	ft.	16
26-50	ft.	14
51-100	ft,	12