assembly and alignment
3.Lower arm until saw blade just clears the front table. Lock the yoke clamp handle and bevel lock lever.
4.Place a framing square on the table as shown and position the blade and square until the leg of the square just contacts a tooth of the blade. Mark this tooth.
NOTE: The | framing | (or | combination) | square |
| must be | |
"true" | see | start | of | "Assembly | and | ||
Alignment" | section | on p. | 8 for | checking | |||
method." |
|
|
|
|
|
| |
5.When the carriage is moved back and forth on the arm, the marked tooth should just touch the square at all
poults. If marked tooth moves into square or away
from square the following adjustments are required:
a. Loosen (3) 3/8 - 16 set screws in arm latch at rear of arm.
_HEX
b. Move the arm in proper direction to make marked tooth follow edge of square when the saw blade is
moved along arm in a "cross cut" manner.
c.Lock arm latch.
d. RETIGHTEN (3) setscrews in arm latch as tight as possible and recheck "cross cut" travel.
NOTE: This squaring of the cross cut travel will
simultaneously set BOTH of the 45 ° miter index positions.
e. Set miter indicator | on 0 ° position as shown. |
BEVEL LOCK
LEVER
D
"L" WRENCH
CLAMP
6.Position the rip (guide) fence, spacer board and rear table board behind the front table board as shown.
7.Install the two table clamps in the holes provided for them at the rear of the saw base, and tighten them securely.
NOTE: The life of your saw table will be lengthened
considerably if you will cover the front table with a
fitted piece of 1/4 inch plywood. This should be tacked
in place for easy replacement. Use of such a cover will allow you to do all cutting into the cover, rather than your table top.
WASHER
REAR | RIP FENCE |
FRONT TABLE
15