Connecting To Power Supply Outlet

Motors, Specifications and Electricat Requirements ,

....

This machine is equipped:witha var able speed motor_ It

_ired for operation on 120V, 60Hz, alternating current.

CAUTION: A direct current motor is used in thisj saw. Changes to the internal wiring will create a fire I

hazard and may also create a shock hazard.

]

For replacement motor and control board, refer to parts list in this manual.

If power cord is worn or cut, or damaged in any way, have it replaced immediately.

WARNING: if not properly grounded, this power tool can cause an electrical shock, particularly when used in damp locations close to plumbing. If an electrical shock occurs there is potential of a sec-

ondary hazard, such as your hands contacting the saw blade.

If you are not sure that your outlet, as pictured below, is properly grounded, have it checked by a qualified electri- cian.

Your unit is for use on 120 volts and has a plug that looks like the illustration below.

This power tool is equipped with a 3-conductorcord and _[ounding type plug which has a grounding prong

._proved by Underwriters' Laboratories. The ground conductor has a green jacket and is attached to the tool housing at one end and to the ground prong in the attach- ment plug at the other end.

This plug requires a mating 3-conductor grounded type outlet as shown.

3-Prong Plug

ProperlyU

Grounded

Outlet

--.., 0

Grounding

Prong

WARNING: Do not permit fingers to touch the termi- nals of plug when installing or removing the plug to or from the outlet.

Plug power cord into a 120V properly grounded type out- let.

If the outlet you are planning to use for the power tool is of the 2-prong type, Do Not Remove Or Alter The Grounding Prong In Any Manner. Use an adapter as shown below and always connect the grounding tug to known ground.

It is recommended that you have a qualified electrician replace the TWO prong outlet with a properly grounded THREE prong outlet.

Grounding Lug
	Make Sure This Is
3-Prong _	Connected to a
Plug	Known Ground
	,g
	Receptacle
Adapter

An adapter, as illustrated, is available for connecting plugs to 2-prong receptacles.

The

the adapter must be connected to a permanent

ground such as to a properly grounded outlet box.

I WARNING: green grounding lug extending from

Not all outlet boxes are properly grounded.

If you are not sure that your outlet box is properly grounded, have it checked by a qualified electrician.

NOTE: The adapter illustrated is for use only if you already have a properly grounded 2-prong receptacle.

The use of any extension cord will cause some loss of power.

Use only 3-wire extension cords which have 3-prong grounding type plugs and 3-prong receptacles which accept the tools plug.

Wire Sizes Required

Length of the(American Wire Gauge

Conductor

Number) 120V Lines

Up to 100 feet

No. 16