Sears 113.23615 manual Dust Blower, Blade, Height AdjustmentKnob Hold-Down, Hold-Down Foot

wARNING: To avoid i'njuryfrom accidental starting,

alwwsturn switch:"OFP and unplug power cord ;, fromoutlet before removing or replacing the blade;

The purpose of the work hold_down foot is to hold the work against the table so that it :isless likely io liftwith:the up stroke of the blade, tt should lie flat on the work with the front prongs straddling the blade.

1.The work hold-down foot is attached to the blade guard wire. The height of the work hold-down foot is adjusted by loosening the height adjustment knob and moving the guide post up or down. The work hold-down foot is adjusted front to back and left-to-right by loosening the hold-down knob located on the bracket, as illustrated

2.When the table is tilted, the work hold-down foot can be adjusted by loosening the height adjustment knob and adiustingthe foot to the same angle as the table. The work hold-downfootshould always be adjusted as close to the blade as: possible without touching and positioned directly on the surface of the workpiece.

breakage _iScaused by:the following: ';_tensi_norunde_tension:

;i:use::!ibiade iiife :exiiaust ed;

;rAggressive_ Feeding of the workpiece into the

:te bygoing too:fast,

OOT

Height

AdjustmentKnob

Hold-Down

Knob _

Hold-Down

Foot

Adjust

Hold-Down

Foot to

Same Angle

as Table

Dust Blower

The dust blower will direct air to the most effective point on the cutting line when the hold down is adjusted. No adjustment is necessary to the blower.

Blade	Guard
The blade		guard will always be positioned parallel to the	i__	iil	-- B/oUSter
blade.	No	adjustment is necessary,