owners
while
Av'oidAccidental Starting.: Make sure switch is "OFF" before plugging Saw into a power outlet.
Plan your work;
o Use The Right Tool, Don'tforce tool or attachment to doa job it Was not designed todo.
,*use this scrolt saw to cut only wood,
CAUTION: This saw is NOT designed for cutting fer- rous metals like iron or steel. When cutting
-Remove all traces of wood dust from inside the
saw.
•Remove all traces of metal dust from on or around the saw before sawing wood again;
Dress for safety.
Any power saw can throw foreign objects into the eyes. This can cause permanent eye damage. Wear safety goggles (not glasses) that comply with ANSI Z87.1 (shown on package), Everyday eyeglasses have only impact resistant lenses. They are not safety glassesi:: Safety goggles: are available :at Sears Retail Stores. Glasses or goggles not in compliance with ANSi Z87.1 could seriously hurt you when they break_
•Do not wear loose clothing, gloves, neckties or jewelry (rings, wristwatches). They can get Caught anddraw you into moving parts,
"* Wear
•Tie back long hair.
°Roll long sleeves above the elbow,
°Noise levels vary widely. To avoid possible hearing damage, wear ear plugs or muffs when using saw for hours at a time.
•For dusty operations, wear a dust mask along with the safety goggles.
Inspect your workpiece.
Make sure there are no nails or foreign objects in the part of the workpiece to be cut.
Usel extra caution With :/large, very smal] or awkward workpieces:
Neve!_uSethis:t00t t0 finish pieces too small to hold bv
ha a | - | .... |
Use extra supports (tables, _saw horses, blocks etc.) for:any workpiece large enough to tip when not held down to the table top.
o Never use another person as a substitute for a table extension, or as additional support for a workpiece or to help feed, support or pull the workpiece
o When cutting irregularly shaped workpieces, plan you r work so it will not pinch the blade. A piece of molding, for example, must lay flat or be held by a fixture or jig that will not let it twist, rock or slip while being cut.
•Properly support round material such as dowel rods or tubing. They have a tendency to roll during a cut, causing the blade to "bite". To avoid this, always use a "V" block,
°Cut only one workpiece at a time.
°Clear everything except the workpiece and related support devices off the table before turning the saw on.
Plan the way you will hold the workpiece from start to finish.
Do not hand hold pieces so small that your fingers will go under the blade guard. Use jigs or fixtures to hold the work and keep your hands away from the blade.
Avoid awkward operations and hand positions where a sudden slip could cause fingers or hand to move Ontothe! blade.
Don'tOverreach. Keep good footing and balance.
Keep your face and body to one side of blade, out of line
....with_apossible thrown piece if the blade should break.
18