68

3 Troubleshooting my computer

 

 

Error Messages

Corrective Action

 

 

One or more I2O Block Storage Devices were excluded from the Setup Boot Menu

There was not enough room in the IPL table to display all installed I2O block-storage devices.

Operating system not

Operating system cannot be located on either

found

drive A: or drive C:. Enter Setup and see if fixed

 

disk and drive A: are properly identified.

 

 

*Parity Check 1 nnnn

Parity error found in the system bus. BIOS

 

attempts to locate the address and display it on

 

the screen. If it cannot locate the address, it

 

displays nnnn. Parity is a method for checking

 

errors in binary data. A parity error indicates that

 

some data has been corrupted.

 

 

*Parity Check 2 nnnn

Parity error found in the I/O bus. BIOS attempts to

 

locate the address and display it on the screen. If

 

it cannot locate the address, it displays nnnn.

Press <F1> to resume, <F2> to Setup, <F3> for previous

Displayed after any recoverable error message. Press <F1> to start the boot process or <F2> to enter Setup and change the settings. Press <F3> to display the previous screen (usually an initialization error of an Option ROM, i.e., an add-on card). Write down and follow the information shown on the screen.

Run the I2O

One or more unclaimed block storage devices

Configuration Utility

have the Configuration Request bit set in the LCT.

 

Run an I2O Configuration Utility (e.g. the SAC

 

utility).

 

 

If you still encounter problems after going through the corrective measures, please contact your dealer or an authorized service center for assistance. Some problems may be solved using the BIOS Setup Utility.

Page 76
Image 76
Acer 280 Series, 230 Series manual Error Messages Corrective Action