66

3 Troubleshooting my computer

 

 

Error Messages

Corrective Action

 

 

*0232 Extended RAM

Extended memory not working or not configured

Failed at offset: nnnn

properly at offset nnnn.

 

 

0250 System battery is

The CMOS clock battery indicator shows the

dead - Replace and run

battery is dead. Replace the battery and run

SETUP

Setup to reconfigure the system.

0251 System CMOS checksum bad - Default configuration used

System CMOS has been corrupted or modified incorrectly, perhaps by an application program that changes data stored in CMOS. The BIOS installed Default Setup Values. If you do not want these values, enter Setup and enter your own values. If the error persists, check the system battery or contact your dealer.

*0260 System timer

The timer test failed. Requires repair of system

error

board.

 

 

*0270 Real time clock

Real-Time Clock fails BIOS hardware test. May

error

require board repair.

 

 

0271 Check date and

BIOS found date or time out of range and reset

time settings

the Real-Time Clock. May require setting legal

 

date (1991-2099).

 

 

0280 Previous boot

Previous POST did not complete successfully. POST

incomplete - Default

loads default values and offers to run Setup. If

configuration used

the failure was caused by incorrect values and

 

they are not corrected, the next boot will likely

 

fail. On systems with control of wait states,

 

improper Setup settings can also terminate POST

 

and cause this error on the next boot. Run Setup

 

and verify that the wait-state configuration is

 

correct. This error is cleared the next time the

 

system is booted.

 

 

0281 Memory Size

Memory size found by POST differed from CMOS.

found by POST differed

 

from CMOS

 

02B0 Diskette drive A error

02B1 Diskette drive B error

Drive A: or B: is present but fails the BIOS POST diskette tests. Check to see that the drive is defined with the proper diskette type in Setup and that the diskette drive is attached correctly.

Page 74
Image 74
Acer 280 Series, 230 Series manual Setup to reconfigure the system