Arranging Embroidery Designs
Transferring Embroidery Designs to Machines
The procedures for transferring the created embroidery pattern to an embroidery machine differ depending on your embroidery machine model. For details, refer to the Operation Manual provided with your embroidery machine.
Transferring to a machine by using an original card
Designs can be transferred to an embroidery machine equipped with a card slot.
a Note:
•Be sure that the hoop size of the design does not exceed the hoop that will be used on the embroidering machine.
•When writing to an original card that already contains data, all data on the card will be deleted. Before writing to a card, save all necessary data to a hard disk or other media, and check that no necessary data remains on the card.
c “Frompage 50an embroidery card” on
c For details on writing multiple embroidery designs, refer to “Writing Multiple Embroidery Files to an Original Card” on page 72.
1.Insert an original card into the USB Card Writer Module.
2. Click | , then | , |
then .
3.When the following message appears, click OK.
→Data transfer begins. The following message appears while the data is being transferred.
4.After the data has been transferred, the following message appears, indicating that the transfer is finished. Click OK.
52