3.Partially install two
IMPORTANT
If you intend to install your ceiling fan without using the light fixture supplied with the fan, or if you are going to use a different Emerson light fixture with your fan, proceed to “Installation of Light Adapter Plate” Section on page 8.
COUPLING
ADAPTER
Figure 13
4.Position the keyhole slots in the light fixture mount- ing plate over the two screws in the coupling adapter (Figure 14). Rotate the mounting plate clockwise to engage the slots under the screw heads, then install a
LIGHT FIXTURE
MOUNTING PLATE
2 INSTALL
3 TIGHTEN TWO
PHILLIPS ROUND HEAD SCREWS
1 ROTATE MOUNTING PLATE CLOCKWISE
Figure 14
RECESSED
PORTION OF
MOUNTING
PLATE
PROVIDES
CLEARANCE
FOR LIGHT
FIXTURE
SWITCHES
LIGHT FIXTURE
MOUNTING PLATE
LIGHT FIXTURE
ASSEMBLY
MOTOR CONNECTOR
LIGHT FIXTURE
CONNECTOR
Figure 15
!WARNING
To avoid possible fire or shock, make sure that the electrical wires are not pinched between the light fixture assembly and the mounting plate.
6.Position the light fixture assembly over the light fixture mounting plate. The light fixture switches must be located in the recessed portion of the mounting plate (Figure 15). Align the holes in the light fixture with the holes in the mounting plate and install four
7.Cut the speed control switch and light control switch pull chains to your desired length (optional). Connect the wood pendant (supplied) to one pull chain by sliding the wood pendant (small hole first) onto the pull chain (Figure 16). Then attach a chain coupling (supplied) to the end of the chain and allow the pendant to slide down over the coupling. Repeat this procedure for the other pull chain.
LIGHT FIXTURE | ||
SWITCHES | ||
FLAT HEAD SCREW (4) | ||
|
LIGHT
FIXTURE
ASSEMBLY
5.Engage the connector from the light fixture assembly with the motor connector (Figure 15). The two connectors are keyed and
can be engaged. Make sure the connector latch closes properly.
7 Figure 16
WOOD PENDANT
CHAIN COUPLING