Using Your Ceiling Fan, Three-Speed | Emerson CF960CK 00 guide

9.Carefully cut the blue wire going to the light switch. Strip off 1/2-inch of insulation and connect this blue wire to the blue wire from the light fixture (Figure

21)using a wire connector (supplied).

10.Carefully cut the white wire going to the two-wire connector. Strip off 1/2-inch of insulation and connect this white wire to the white wire from the light fixture (Figure 21) using a wire connector (supplied).

11.Engage the connector from the light adapter plate with the connector from the motor assembly (Figure 15). The two connectors are keyed and color-coded and must be mated correctly (color-to-color) before they can be engaged. Make sure the connector latch closes properly.

ADAPTER PLATE SWITCHES

Figure 22

5/32-32 x 5/16" PHILLIPS FLAT HEAD SCREW (4)

LIGHT

ADAPTER

PLATE

WOOD PENDANT

CHAIN COUPLING

!WARNING

To avoid possible fire or shock, make sure that the electrical wires are not pinched between the light adapter plate and the mounting plate.

TWO-WIRE

CONNECTOR

3	CUT WHITE	LIGHT
	WIRE HERE	SWITCH
		SWITCH

4 CONNECT TO WHITE WIRE FROM LIGHT FIXTURE

1 CUT BLUE WIRE HERE

2 CONNECT TO BLUE WIRE FROM LIGHT FIXTURE

Figure 21

12.Position the light adapter plate over the light fixture mounting plate. The adapter plate switches must be located in the recessed portion of the mounting plate (Figure 15). Align the holes in the adapter plate with the holes in the mounting plate and install four 5/32-32 x 5/16” Phillips flat head screws (supplied) (Figure 22).

13. Cut the speed control switch pull chain to your desired length (optional). Connect the wood pendant (supplied) to the pull chain by sliding the wood pendant (small hole first) onto the pull chain (Figure 22). Then attach a chain coupling (supplied) to the end of the chain and allow the pendant to slide down over the coupling.

Using Your Ceiling Fan

1.Restore electrical power to the outlet box by turning the electricity on at the main fuse box.

2.Check the operation of the fan by gently pulling on the speed control pull chain switch (Figure 23). The operating sequence is as follows:

THREE-SPEED

1st Pull—HIGH 2nd Pull—Medium 3rd Pull—Low 4th Pull—OFF

LIGHT CONTROL	SPEED CONTROL
SWITCH	SWITCH
	REVERSING
Figure 23	SWITCH

3.If airflow is desired in opposite direction, turn your fan off and wait for the blades to stop turning, then slide the reversing switch to the opposite position, and turn the fan on again. The fan blades will turn in the opposite direction and reverse airflow.

4.Check the operation of the light fixture by gently pulling on the light control pull chain switch.