Emerson CF960BS 00, CF960CK 00, CF960WB 00 owner manual Installation Light Adapter Plate

Page 8

Installation of

Light Adapter Plate

IMPORTANT

Perform the procedures in this Section ONLY if you intent to install your ceiling fan without using the light fixture supplied with the fan, or if you are going to use a different Emerson light fixture with your fan.

NOTE: In order to use the light adapter plate (supplied), the wiring harness included as part of the light fixture assembly must be removed and be reinstalled in the light adapter plate. This Section contains the procedures to accomplish this.

1.Disconnect the light fixture connector from the wiring harness connector (Figure 17). Unscrew the knurled nuts from the light switch and the speed control switch. (The knurled nuts are not interchangeable; keep them with their respective switch.) Gently pry the capacitor (secured by two-sided tape) from the light fixture assembly.

CAPACITOR

LIGHT FIXTURE

ASSEMBLY

SPEED CONTROL

SWITCH

KNURLED

NUT

DISCONNECT

 

THE LIGHT

 

FIXTURE

WIRING

CONNECTOR

HARNESS

FROM THE

CONNECTOR

WIRING

 

HARNESS

LIGHT SWITCH

CONNECTOR

KNURLED NUT

Figure 17

2.Remove and retain the two screws securing the reversing switch to the light fixture (Figure 18). Remove and retain the harness assembly.

3.Remove the knurled nut from one of the switch chain bushings (Figure 18). Retain the knurled nut

and bushing for installation in the next step.

SWITCH CHAIN

BUSHING

KNURLED NUT

SCREW (2)

LIGHT FIXTURE

ASSEMBLY

REVERSING

SWITCH

Figure 18

8

 

4.Position the switch chain bushing in the hole in the light adapter plate (Figure 19) and secure using the knurled nut.

SWITCH CHAIN

BUSHING

KNURLED NUT

SCREW (2)

LIGHT ADAPTER

PLATE

Figure 19

REVERSING

SWITCH

5.Position the two switches of the harness assembly in the mounting bracket; the small switch (light switch) installs in the left hole and the larger switch (speed control switch) installs in the right hole (Figure 20). Secure the switches using the appropriate knurled nuts. Pass the speed control switch chain through the chain bushing. If desired, tape the other switch chain to the adapter plate as shown (tape not supplied).

CAPACITOR

LIGHT ADAPTER

PLATE

SPEED CONTROL

SWITCH

KNURLED

NUT

SCREW

PLUG

CHAIN BUSHING

TAPE

LIGHT SWITCH

KNURLED NUT

MOUNTING BRACKET

Figure 20

6.Remove one protective covering from the two- sided foam tape (supplied) and apply the foam tape to the capacitor. Remove the remaining protective covering and then firmly press the capacitor onto the adapter plate (Figure 20).

7.Position the reversing switch in the slot in the adapter plate and secure using two screws (Figure 19).

IMPORTANT

The next three steps (step 8, 9 and 10) are to be performed ONLY if you are installing an optional Emerson light fixture. If you are installing your fan without a light fixture, proceed to step 11.

8.Remove the screw plug (Figure 20) from the bottom of the light adapter plate and install your optional Emerson light fixture in accordance with the light fixture Owner’s Manual.

Image 8
Contents Windjammer Safety Instructions Unpacking Instructions Assembling and Hanging Ceiling Fan As described above, or fan wobble could resultSupply Wires Wiring Your Ceiling Fan Final Assembly Ceiling FanCoupling Adapter Installation Light Adapter Plate Using Your Ceiling Fan THREE-SPEEDTrouble Shooting MaintenanceAccessories Repair Parts HOW to Order Repair PartsRepair Parts Listing Model No Key Description