Husqvarna K 3600 MKII manual Settings and Adjustments

Page 12

SETTINGS AND ADJUSTMENTS

Loosen the knob to offload the springs.

Pull out the lock for the front handle and move the handle to the service position.

Remove the three screws holding the support roller guard using a 6 mm hex key and lift off the cover.

Fit the blade.

CAUTION! The blade has a groove (A) on one side that acts a the guide groove for the support rollers. Ensure that the V-shaped edge of the blade enters the drive wheel and that the blade’s guide groove fits in the guide rollers. Also see under the heading Drive.

Press in the guide roller if necessary, so that it climbs into the groove on the blade.

Fit the support roller guard and ensure that the flanges on the guide rollers still enter the blade’s grooves correctly. Now tighten the three screws fully.

Rotate the blade and make sure that the support rollers are not clamped against the blade.

Adjust the adjuster screws so that the support rollers make contact against the blade.

Adjust so you can easily stop the support rollers using your thumb when the blade is rotated. The support rollers should only follow the blade occasionally.

Tighten the locking nuts on the support roller guard.

Rotate the blade and make sure you can still hold the rollers with your thumb when the blade is rotated.

12 – English

Image 12
Contents Mkii EnglishKEY to Symbols Key to symbolsContents What is WHAT? What is what on the power cutter?Safety Instructions Steps before using a new power cutterMachine′s safety equipment SwitchSwitch lock and ON/OFF valve for the water Checking the starting and stopping functions of the switchChecking the switch lock Blade guardGeneral safety precautions Basic safety rulesGeneral working instructions Checking the blade guardCutting Cutting techniqueHow to avoid kickback Diamond blades Sticks to the bladeSettings and Adjustments Basic serviceDrive Fitting the bladeSettings and Adjustments Hydraulic hoses Water hoseWater supply Water dosageStarting and Stopping Starting and stoppingStarting StoppingMaintenance MaintenanceDismantling the complete guide roller Assembling the complete guide rollerDrive wheel Replacing the support rollers/guide rollersReconstructing the blade Couplings Maintenance schedule Blades conforming to EN13236Trouble Shooting Symptom Probable causeMechanics Technical Data Extending the hydraulic hosesEC-declaration of conformity ´z+UBT¶6A¨ Page Original instructions 1153345-26 ´z+UBT¶6A¨ ´z+UBT¶6A¨