Husqvarna K 3600 MKII manual Drive wheel, Replacing the support rollers/guide rollers

Page 16

MAINTENANCE

Drive wheel

1Lock the axle using the locking button. See the instructions under the heading What is what?.

2Loosen the centre screw and remove the washer.

3 You can now lift off the drive wheel.

CAUTION! Replace the drive wheel when fitting a new blade. A worn drive wheel can result in the blade slipping and becoming damaged.

Inadequate water flow drastically shortens the life of the drive wheel.

Replacing the support rollers/guide rollers

Remove the support roller cover.

Check the rollers for wear.

Use a 19 mm spanner and 5 mm hex key to replace the rollers.

Lubricate using bearing grease inside the rollers before the new rollers are fitted.

Replace the guide rollers when half of the flange on the rollers is worn.

A) New

B) Worn

Replace the support rollers when the roller surface is flat, (or) when the groove on the roller surface has worn away.

A)New

B)Worn

When worn rollers are replaced with new ones, you must adjust the rollers against the blade. See the instructions under the heading Settings and adjustments.

16 – English

Image 16
Contents Mkii EnglishKEY to Symbols Key to symbolsContents What is WHAT? What is what on the power cutter?Safety Instructions Steps before using a new power cutterMachine′s safety equipment SwitchSwitch lock and ON/OFF valve for the water Checking the starting and stopping functions of the switchChecking the switch lock Blade guardGeneral safety precautions Basic safety rulesGeneral working instructions Checking the blade guardCutting Cutting techniqueHow to avoid kickback Diamond blades Sticks to the bladeSettings and Adjustments Basic serviceDrive Fitting the bladeSettings and Adjustments Hydraulic hoses Water hoseWater supply Water dosageStarting and Stopping Starting and stoppingStarting StoppingMaintenance MaintenanceDismantling the complete guide roller Assembling the complete guide rollerDrive wheel Replacing the support rollers/guide rollersReconstructing the blade Couplings Maintenance schedule Blades conforming to EN13236Symptom Probable cause Trouble ShootingMechanics Technical Data Extending the hydraulic hosesEC-declaration of conformity ´z+UBT¶6A¨ Page Original instructions 1153345-26 ´z+UBT¶6A¨ ´z+UBT¶6A¨