Husqvarna 4000 manuel dutilisation Technical Specifications, Conformity Certificates

TECHNICAL SPECIFICATIONS

Weight and Dimensions 4000
Weight – dry	440 lbs	200 kg
Weight with gasoline and oil full	454 lbs	206 kg
Length	61 inch	1549 mm
Width	28 inch	711 mm
Height	38 inch	965 mm
Blade
Material cut	Green concrete only
Blade type	13.5” (343 mm) or 12.0” (305 mm) dry cut with tri-arbor
Blade rotation	Counter clockwise, upcutting
Blade shaft speed	3500 rpm
Cutting depth	3 inch maximum (76 mm) depending on blade size and
	amount of blade wear
Cutting distance from wall	3 1/2 inch	89 mm

Average cutting rate - Estimate only. Speed will vary with job conditions and concrete mixes.

	3 inch (76 mm) depth	2 inch (51 mm) depth
Soft aggregates	14 ft/min (4.3 m/min)	24 ft/min (7.3 m/min)
Medium aggregates	11 ft/min (3.4 m/min)	17 ft/min (5.2 m/min)
Hard aggregates	7 ft/min (2.1 m/min)	9 ft/min (2.7 m/mim)
Blades are available in 13.5 inch (343 mm) and 12 inch (305 mm) diameters and in 0.100 inch (2.5 mm),
0.250 inch (6.4 mm), 0.380 inch (9.7 mm), and 0.500 inch (12.7 mm) widths
Engine:	Kohler Command Pro CH18S
Engine oil volume	2 quarts	1.9 liters
Gasoline tank volume	4.5 gal	17 liters
Type	Air cooled, 4-cycle, twin cylinder, hydraulic overhead
	valves, gasoline engine
Air filter	Dual element construction duty
Oil system	Full pressure lubrication with spin-on oil filter
Muffler	Low noise, front exhaust
Emissions	Complies with EPA Phase 2 and CARB Tier II USA
	regulations
Cooling	Air cooled
Cylinder	Aluminum with cast iron liner
Controls	Engine mounted manual throttle and choke levers,
	manual on/off switch

CONFORMITY CERTIFICATES

CALIFORNIA AIR RESOURCES BOARD (CARB): This machine is considered a preempt Off-Road Application­ as relating to CARB standards. Under construction equipment, and in particular, as a Saws : concrete, masonry, cutoff, with engine power less than 19KW (25hp), CARB standards do not apply to this machine.

For more information see the website http://www.arb.ca.gov/msprog/offroad/preempt.htm

15