| CONTENTS |
|
Content | Page | |
Table of contents | ………………………….. | 2 |
Unpacking | 2 | |
Transporting | 2 | |
Sound Data | 2 | |
Introduction, personal safety | 3 | |
Registration of the product ………………… | 4 | |
General safety message | 4 | |
Safety warnings | 5 | |
Excel series blades | 6 | |
Blade and skid plate installation | 6 | |
What is what? | 7 | |
Operating instructions | 8 | |
Fuel and fuel safety warnings …….…….... | 9 | |
Recommended fuels | 9 | |
Recommended oils …….......……….…..… | 9 | |
Engine and transmission maintenance | 10 | |
Other maintenance ………………….…….. | 11 | |
Sawing contraction joints …………....….… | 12 | |
Maximizing the | 13 | |
Troubleshooting | 14 | |
Technical specifications | 15 | |
Conformity certificates | 15 | |
Warranty | 16 | |
UNPACKING
Your 4000 saw has been shipped from the factory thoroughly inspected. Only minimal assembly is required to start using the saw. Remove the saw from the container using proper lift- ing techniques. Discard or recycle the packing material per your regional laws. In your container will be the 4000 saw, blade shaft wrench, spark plug wrench, an owner’s manual, an engine owner’s manual, a part list, a warranty card, a joint protector sample pack and a ramp for unloading the saw. Con- nect the battery cables and turn the key switch to the “ON” or “1” position. Press the rocker switch on the instrument panel to raise the saw. Place the unloading ramp at the edge of the container and roll the saw out of the container. Lower the saw and turn the key switch to the “OFF” or “0” position.
NOTE: No diamond cutting blade or skid plate is included with the saw. Purchase the appropriate Husqvarna Excel Series 12 or 13.5 inch blade from your local Husqvarna Construction Product dealer.
TRANSPORTING
The 4000 saw weights approximately 454 pounds (206 ki- lograms) when ready to use . Use safe lifting practices when handling the saw. Always remove the diamond blade when transporting the saw. Always transport the saw with a skid plate installed. Fold the guide arm back. The saw can be lifted from the center hook on the roll cage. Always store and trans- port the saw in a completely lowered position and secured from moving.
Lifting point
Roll cage
Handle bar
Front guide
Rear guide
CAUTION
Only use the center hook on the roll cage when lifting the 4000.
SOUND DATA
According to Standard ISO 3744:1998 and Directive 2000/14/ EC for environmental sound level and according to Standard ISO 11201:1995 for sound level at the operator’s position, the
4000 saw emits the following:
Sound power level | Lwa 109 dB (A) |
Sound pressure level | Lpa 91 dB (A) |
WARNING
Always wear safety approved hearing protection.
2