Husqvarna k2500 manual ´z+R=@¶6r¨ 14 English´z+R=@¶6r¨, Daily maintenance

Page 14

MAINTENANCE

Daily maintenance

Carry out the following checks daily before using the machine.

1Check that nuts and screws are tight.

2Check that the power source (the hydraulic unit) supplies the correct oil ﬂow and oil pressure.

3Check that the hydraulic hoses and couplings are clean and undamaged.

4Connect the machine hoses with the hoses from the power source.

5Start the power source and check that the power cutter functions by starting the machine with the switch in the rear handle. Check that the blade stops when the switch is released.

6Checking the blade guard

7Check the condition of the cutting blade.

8Check the tension of the drive belt.

´®z+R=@¶6r¨ 14 – English´®z+R=@¶6r¨

Image 14

Contents K2500 KEY to Symbols Key to symbolsContents What is WHAT? What is what on the power cutter?Machine′s safety equipment Safety InstructionsSteps before using a new power cutter SwitchGeneral safety precautions Transport and storage Basic safety rulesGeneral working instructions CuttingSharpening diamond blades How to avoid kickbackWhat is kickback? Blade vibrationAbrasive discs Cutting bladesGeneral Diamond blades for dry cutting Diamond bladesDiamond blades for wet cutting MaterialFitting the cutting blade AssemblyAssembly Guard for the bladeStarting Starting and StoppingStarting and stopping StoppingMaintenance MaintenanceDaily maintenance ´z+R=@¶6r¨ 14 English´z+R=@¶6r¨Cutting equipment Technical DataTechnical data EC-declaration of conformity1150293-26 ´z+R=@¶6r¨ ´z+R=@¶6r¨