Hobart Welding Products XVX manual Replacing the Lens Covers, Replacing Outside Lens Cover

Page 10

SECTION 5 − REPLACING THE LENS COVERS

5-1. Replacing Outside Lens Cover

			!	Never use the auto-darkening
				lens without the inside and
				outside lens covers properly
	2	1	2	installed. Welding spatter will
	2	1	2	damage the auto-darkening
				damage the auto-darkening
				lens and void the warranty.
			1	Front Lens Holder
			2	Release Points
			3	Lens Cover
			4	Gasket
			Remove front lens holder by press-
			ing release points and pulling the
			holder away from the helmet.
			Remove lens cover and gasket from
			the holder. Replace lens cover and
			reinstall gasket and lens in holder.
			Reinstall holder in helmet.
			. Be sure the flat side of lens
				cover gasket faces the lens cov-
				er holder.

Be sure flat side of gasket faces lens cover holder.

4

3	8804 814 / 804 816

OM-240 362 Page 8

Image 10

Contents OM-240 362B 2008−11Table of Contents Hazards ARC Rays can burn eyes and skin − Safety Precautions − Read Before UsingSymbol Usage Noise can damage hearing− Specifications Storage Temperature −4F to 158F / −20C to +70CSee Section − Operating InstructionsHelmet Controls Variable Shade Control SeeReset Button And Low Battery Indicator Lens Delay Control50−100 Variable Shade Control No −40−80 80−175 60−150130−50% sensitivity setting for most ap Plications Recommended Sensitivity SettingsWeld Mode Grind Mode− Adjusting Headgear Replacing Outside Lens Cover − Replacing the Lens CoversLens without the inside Lens Assembly Inside Lens Cover Replacing Inside Lens Cover− Replacing the Battery − Installing Optional Magnifying Lens − Maintenance− Troubleshooting − Parts List Prowler Auto-Darkening Welding HelmetPart Description Quantity − Limited Warranty Effective January 1Page Page Hobart Welders