Hobart Welding Products XVX manual Replacing the Battery

Page 12

SECTION 6 − REPLACING THE BATTERY

To replace the batteries, remove

the auto-darkening lens assembly (see Section 5).

1 Battery Tray

After removing the lens assembly, slide the battery holding trays out and remove the old batteries.

Replace with CR2450 lithium type batteries (2 required) or equivalent (Hobart Part No. 770 284).

. Be sure Positive (+) side of the

battery faces up (toward inside of helmet).

Reinstall the battery trays. To test, press the Reset button. The lens should flash dark twice. Reinstall the lens assembly.

. Left and right battery trays are not interchangeable. The auto−darkening helmet will not work if battery trays are installed on the wrong sides.

Be sure Positive (+) side of battery faces up.

+

+

1

804 847

OM-240 362 Page 10

Page 11 Page 13
Image 12
Page 11 Page 13
Contents OM-240 362B 2008−11Table of Contents − Safety Precautions − Read Before Using Symbol UsageHazards ARC Rays can burn eyes and skin Noise can damage hearing− Specifications Storage Temperature −4F to 158F / −20C to +70C− Operating Instructions Helmet ControlsSee Section Variable Shade Control SeeReset Button And Low Battery Indicator Lens Delay ControlVariable Shade Control No − 40−80 80−17550−100 60−150Recommended Sensitivity Settings Weld Mode130−50% sensitivity setting for most ap Plications Grind Mode− Adjusting Headgear − Replacing the Lens Covers Replacing Outside Lens CoverLens without the inside Lens Assembly Inside Lens Cover Replacing Inside Lens Cover− Replacing the Battery − Installing Optional Magnifying Lens − Maintenance− Troubleshooting − Parts List Prowler Auto-Darkening Welding HelmetPart Description Quantity − Limited Warranty Effective January 1Page Page Hobart Welders
Top Page Image Contents