Delta 46-756 Tailstock Live Center, Adjusting Clamps on the Headstock and Tailstock, Tool Rest

Page 10

TAILSTOCK LIVE CENTER

The tailstock live center (A) Fig. 14, supplied with your lathe, is equipped with a No. 2 Morse Taper shank.

NOTE: Before inserting the live center, clean both the shank and the inside of the tailstock to remove any grease or debris. To remove the live center (A) from the tailstock spindle (B), use the knockout bar (C) Fig. 14 (supplied) through the hole (D) in the opposite end of the spindle.

ADJUSTING CLAMPS ON THE HEADSTOCK AND TAILSTOCK

The headstock and tailstock can be moved along the lathe bed. A downward push on the handle (A) Fig. 15 (tailstock shown) locks the mechanism, while an upward movement of the handle releases the securing action. The clamps are pre-set at the factory. However, should either need adjusting, use an 11/16” wrench (B) Fig. 15 to slightly loosen or tighten the two nuts (C) Fig. 15 shown here on the tailstock.

NOTE: Tighten or loosen both nuts equally.

NOTE: Clamp the headstock and tailstock firmly while operating the lathe.

TOOL REST

The tool rest (A) and tool rest base (B) are shown in Fig.

16.To position the tool rest on the lathe bed, lift the clamp handle (C), move the tool rest base and lock it in place by pushing down on the handle (C). To adjust the tool rest (A) for the correct height, loosen the locking lever (D), move the tool rest (A) up or down and tighten the locking lever (D).

NOTE: The locking lever (D) Fig. 16 can be positioned on the left or right side of the tool rest base (B). To repo- sition the tool rest locking lever (D), unscrew the lever counterclockwise. A threaded hole is provided in the left side of tool rest base (B) to accept the locking lever (D) if desired.

NOTE: Clamp the tool rest firmly while operating the lathe.

ADJUSTING CLAMP ON

TOOL REST

To adjust the tool rest clamping action, use a 11/16” wrench to loosen or tighten the single nut (A) Fig. 17.

A

D

B

 

C

Fig. 14

A

B

Fig. 15

C

A

B

D

Fig. 16

C

A

Fig. 17

10

Image 10
Contents Variable Speed Wood Lathe Safety Guidelines Definitions General Safety RulesFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Wood Lathes Motor Specifications Power ConnectionsGrounding Instructions Extension Cords 150 250 volts, inclusiveUnpacking and Cleaning Functional DescriptionAssembly Attaching Lathe BED To PedestalsAttaching LEG Inserts Tailstock Live Center Adjusting Clamps on the Headstock and TailstockAdjusting Clamp on Tool Rest Tool RestStarting and Stopping the Tool Locking Switch in the OFF PositionActivating the Spindle Changing ACCELERATION/DECELERATION Lathe Tools HOW to Turn SpindlesCentering the Work Mounting the Work Tool Rest PositionRoughing a Cylinder Position of HandsSmoothing a Cylinder Using the Parting ToolSquaring AN END Cutting a Shoulder Cutting Small BeadsLong Cuts VEE GroovesCove Cuts Square Sections Mounting Work to Faceplate Faceplate TurningOutboard Turning Maintenance Replacing Drive BeltLubrication Accessories Keep Machine CleanCanadian PORTER-CABLE Delta Service Centers