Delta 46-756, 46-755X instruction manual Lubrication

Page 22

B

A

Fig. 74

B

A

Fig. 75

5.Use a Phillips screwdriver (A) Fig. 74 to remove the five cover screws (B) (three of which are shown). The other two screws are located under the power cords.

6.With a 5/16” hex wrench (A) Fig 75, remove the hex screw (B) Fig. 75. NOTE: When re-assembling, pass the screw completely through the pivoting control bracket and into the headstock, allowing the headstock cover to pivot.

A

B

Fig. 76

A

Fig. 77

7.While holding the control panel (A) Fig. 76 with one hand, remove the cover (B) Fig. 76. To prevent the control panel

(A) from falling, loosely re-attach the hex screw (B) Fig. 75 to the control panel.

8.Replace the belt (A) Fig. 77.

9.To assemble, reverse the procedure.

A

B

Fig. 78

B

A

Fig. 79

LUBRICATION

Use a light oil to lubricate eccentric (A) Fig. 78, and pivot points (B) on both the headstock and the tailstock. (Tailstock illustrated).

Use the tip of a screwdriver (A) Fig. 79 to press on the opening, and drop light oil into the handwheel cover (B) of the tailstock.

22

Image 22
Contents Variable Speed Wood Lathe Safety Guidelines Definitions General Safety RulesFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Wood Lathes Motor Specifications Power ConnectionsGrounding Instructions Extension Cords 150 250 volts, inclusiveUnpacking and Cleaning Functional DescriptionAssembly Attaching Lathe BED To PedestalsAttaching LEG Inserts Tailstock Live Center Adjusting Clamps on the Headstock and TailstockAdjusting Clamp on Tool Rest Tool RestStarting and Stopping the Tool Locking Switch in the OFF PositionActivating the Spindle Changing ACCELERATION/DECELERATION Lathe Tools HOW to Turn SpindlesCentering the Work Mounting the Work Tool Rest PositionRoughing a Cylinder Position of HandsSmoothing a Cylinder Using the Parting ToolSquaring AN END Cutting a Shoulder Cutting Small BeadsLong Cuts VEE GroovesCove Cuts Square Sections Mounting Work to Faceplate Faceplate TurningOutboard Turning Maintenance Replacing Drive BeltLubrication Accessories Keep Machine CleanCanadian PORTER-CABLE Delta Service Centers