Delta 46-755X, 46-756 instruction manual Roughing a Cylinder, Position of Hands

Page 15

ROUGHING A CYLINDER

The large gouge is used in the first turning operation by smoothing the sharp corners of the work. Run the lathe at low speed and hold the gouge in the manner shown in Fig. 33 The cut starts about 2 inches from the tailstock end and continues from this point to the end of the tail- stock. Make the second pass beginning about 2” or 3” to the left of the first cut. Advance again toward the tailstock, and merge with the previous cut. Toward the end of the live center, roll the gouge in the opposite direction (Fig. 34) to carry the final cut off the live center end of the work. The roughing cut should not be carried out with one continuous movement, because this would tear long slivers from the corners of the work. Neither should the cut be started directly at the end of the stock for the same reason. The cut can be safely carried from the center of the stock toward and off either end once the first roughing cuts have been made.

The position of the gouge involves two or three important angles. (1) The tool may be advanced along the work either from right to left or from left to right. Left to right (from headstock to tailstock) is preferred since this action throws chips clear of the operator. (2) The gouge is rolled over slightly in the same direction it is advancing. (3) The tool is held well up on the work, with the bevel or grind tangent to the revolving surface (Fig. 35). This position will give a clean shearing cut. When pushed straight into the work (Fig. 35), the gouge has a scraping action, (normally a poor practice in spindle turning). The roughing cut is continued until the work approaches 1/8” of the required diameter. Once a cylindrical form has been obtained, the turning speed can be moved to the second or third speed setting. NOTE: Continue to move the tool rest inward toward the work piece to keep the safe distance between the two.

POSITION OF HANDS

While turning, the hand that holds the tool handle should be in a natural position. This hand provides the leverage for the tool by either moving in toward the chisel or moving out. The position of the tool rest hand is more a matter of individual preference, rather than a “set” or “proper” position. However, a palm-up grip (Fig. 36) is generally considered best. In this position, the first finger acts as a guide, sliding along the tool rest as the cut is made. The alternate position is a palm-down grip (Fig. 37). In this position, the heel of the hand or the little finger serves as a guide. The palm-down position is solid and positive – excellent for roughing or heavy cutting. Most beginners start with the palm-down grip, switching later to the palm-up position for better manipulation of the chisel.

Fig. 33

Fig. 34

Fig. 35

Fig. 36

Fig. 37

15

Image 15
Contents Variable Speed Wood Lathe General Safety Rules Safety Guidelines DefinitionsFailure to Follow These Rules MAY Result in Serious Injury Additional Safety Rules for Wood Lathes Power Connections Motor SpecificationsGrounding Instructions 150 250 volts, inclusive Extension CordsFunctional Description Unpacking and CleaningAttaching Lathe BED To Pedestals AssemblyAttaching LEG Inserts Tool Rest Adjusting Clamps on the Headstock and TailstockAdjusting Clamp on Tool Rest Tailstock Live CenterLocking Switch in the OFF Position Starting and Stopping the ToolActivating the Spindle Changing ACCELERATION/DECELERATION HOW to Turn Spindles Lathe ToolsCentering the Work Tool Rest Position Mounting the WorkPosition of Hands Roughing a CylinderUsing the Parting Tool Smoothing a CylinderSquaring AN END Cutting Small Beads Cutting a ShoulderVEE Grooves Long CutsCove Cuts Square Sections Faceplate Turning Mounting Work to FaceplateOutboard Turning Replacing Drive Belt MaintenanceLubrication Keep Machine Clean AccessoriesCanadian PORTER-CABLE Delta Service Centers