Lucent Technologies 555-670-116 manual Technical Addendum, Maintenance Error Codes-Continued, 6C07

MERLIN LEGEND Communications System Release 7.0			Issue 1
Pocket Reference 555-670-116			April 1999
Reference Documents			117
		Technical Addendum
	Maintenance Error Codes—Continued
	Error
	Code Description	Action

6C06 DS1 REMOTE MULTIFRAME:

Far end of network interface is experiencing loss of multiframe; service on link has been lost.

Usually no action. Check T1 facility. If problem persists, contact NSAC Tier III.

6C07	DS1 MAJOR ALARM:	Usually no action. Check T1
	Average bit error rate exceeds	facility. If problem persists,
		contact NSAC Tier III.
	10E-3; service on link has been
		Maintenance→Slot→
	lost.
		Error Events→
		Current hr
6C08	DS1 MINOR ALARM:	Usually no action. Check T1
	Average bit error rate exceeds	facility. If problem persists,
		contact NSAC Tier III.
	10E-6.
		Maintenance→Slot→
		Error Events→
		Current hr
6C09	DS1 MISFRAME ALARM:	Usually no action. Check T1
	Misframe count reached 18.	facility. If problem persists,
		contact NSAC Tier III.
		Maintenance→Slot→
		Error Events→
		Current hr
6C0A	DS1 SLIP ALARM:	Usually no action. Check T1
	Slip count reached 88.	facility. If problem persists,
		contact NSAC Tier III.
		Maintenance→Slot→
		Error Events→
		Current hr
6C0B	HARDWARE INOPERATIVE:	A Busy-Out/Restore or Reset/
	Hardware not operating properly.	Restore may clear problem. If
	If this is the only 100D module or	problem persists, contact NSAC
	800 NI-BRI module, or if this is the	Tier III.
	designated clock module, its tdm
	bus clock generator was not
	activated.
6C0C	BRI LOSS OF SYNC:	Usually none; check BRI facility.
	Service on link has been lost.	If problem persists, contact

NSAC Tier III.

6C0D BRI SLIPS > 88:

Slip count > 88. Service on link is still operative.

Usually none; check BRI facility. If problem persists, contact NSAC Tier III.

6C0E BRI NET REQUESTED CCRCs:

Outgoing signal to the network does not have valid framing information. Service on link is still operative.

Usually none; link should return to normal once test is completed. If problem persists, contact NSAC Tier III.

6C0F BRI NET DEACTIVATE:

Layer 1 of the link is down. Service on link has been lost.

Usually none; link should return to normal once test is completed. If problem persists, contact NSAC Tier III.