Lucent Technologies 555-670-116 Technical Addendum, Maintenance Error Codes-Continued, Issue

MERLIN LEGEND Communications System Release 7.0				Issue 1
Pocket Reference 555-670-116				April 1999
Reference Documents			115
		Technical Addendum
	Maintenance Error Codes—Continued
	Error
	Code Description	Action

1C05 INVALID FMW 29

DETECTED:

Incompatibility problem; specified video endpoint or UDM is connected to an 008 or 408 MLX module with firmware of vintage 0x29.

Replace 008 or 408 MLX module with one of another firmware vintage. Retire permanent alarm manually.

1C06 BAD BOARDS IN SYSTEM:

At least one incompatibility problem of type HER 0x1C05 detected. Turns on red LED on processor.

Replace 008 or 408 MLX module with one of another firmware vintage. Retire permanent alarm manually.

1C07	See error code 0801
2C01	T1 ACCESS VIOLATION: Check facility provisioning and re-

T1 services (channels-voice/	administer channels for voice or
	data. Ensure that T1 data facilities
data) programmed incorrectly.
	are accessed from data terminals
	only (such as UDMs or desktop
	video systems) and that T1 voice
	facilities are accessed from
	telephones only (such as MLX
	telephones).

2C02 Bearer Capability Incompatibility:

A64 kbps clear-channel data call was routed to a facility that does not have sufficient bandwidth to handle the call.

Verify that the ARS or UDP routing tables route a data call to a DS1 facility. Check the DS1 Type administration item for the specified facility. If the programmed value is T1, the caller must initiate a 56 kbps call. Check the DS1 Suppression administration item for the specified facility. If the programmed value is AMI-ZCS, the caller must initiate a 56 kbps call.

3001	ALARM TABLE FULL:	Correct indicated errors, and then
	error logs are full; turns on	remove entries from the transient
		system error log. If problem
	processor led.
		persists, cold-start the system.
		SysProgram→System→
		Restart
4401	USER REQUESTED SYS	If error remains in transient log,
	ERASE:	repeat System Erase. If problem
		persists, check processor.
	Logged after System Erase. If
	System Erase is successful, this
	error is removed immediately.
4402	USER REQST	None.
	UPGRD/INSTALL: