Lucent Technologies 555-670-116 Technical Addendum, Maintenance Error Codes-Continued, Issue

MERLIN LEGEND Communications System Release 7.0			Issue 1
Pocket Reference 555-670-116			April 1999
Reference Documents			121
		Technical Addendum
	Maintenance Error Codes—Continued
	Error
	Code Description	Action

8402 WINK TOO SHORT:

Outbound dialing problems on tie trunks. Wink from the far end of network interface is less than 100 ms, the minimum for delay-dial or wink-start tie trunks. Tie trunk waits for valid signal.

Check far end of network. Check for faulty cable. Replace module.

8403 NO EXTERNAL RELEASE:

Communication problems between module and CO. Far end has not disconnected within 4 minutes. If error occurs twice consecutively, trunk is busied-out automatically whether or not automatic maintenance-busy is enabled.

Check far end of network interface. Check for faulty cable.

8404 ON HOOK BEFORE WINK:

Outbound dialing problems on tie trunks. Far end of network interface went on-hook before handshake was completed (for delay-dial or wink-start tie trunk).

If problem persists, check tie trunk configuration. Check far end. Check for faulty cable.

Replace module.

8405 ON HOOK BEFORE READY:

Outbound dialing problems on tie trunks. Far end of network interface went on-hook before guard time elapsed (for delay-dial or wink-start tie trunk).

Check far end of network interface. Check wink start and for faulty cable. Check far end of network. Replace module.

8406	INTERDIGIT TOO SHORT:	Check far end of network
	Inbound dialing problems on tie	interface. Check for faulty cable.
		Replace module.
	and DID trunks.
8407	BAD UPDATE:	Turn processor off and then on.
	Communication problems	Repeat system programming
		procedure. If problem persists,
	between processor and modules;
	module may need to be replaced.	contact NSAC Tier III.
8408	ROTARY RATE > 12PPS:	Check far end of network
	Inbound dialing problems on tie	interface. Check for faulty cable.
		Replace module.
	and did trunks.
8409	ROTARY RATE < 8PPS:	Check far end of network
	Inbound dialing problems on tie	interface. Check for faulty cable.
		Replace module.
	and did trunks.
840A	BAD DOWNLINK MESSAGE:	Turn processor off and then on.
	Communication problems	Repeat system programming
		procedure. If problem persists,
	between processor and modules;
	module received an unrecognized	replace module.

message from processor.