N039884 - JULY09 - REV0
46-462 MIDI-LATHE STAND
For use ONLY with Delta
iF YoU HAVE ANY QUESTioNS oR CoMMENTS ABoUT THiS oR ANY DELTA MACHINERY ACCESSORY, CALL US ToLL FREE AT
Safety Instructions
To reduce the risk of injury, read the tool instruction manual before using any accessory. Failure to heed these warnings may result in personal injury and serious damage to the tool and the accessory. When servicing this tool, use only identical replace ment parts.
To reduce the risk of injury, turn tool off and disconnect it from power source before installing and removing accessories, before adjusting or when making repairs. An accidental
To reduce risk of injury, this product should only be used with Delta
A.
B.
C.
D.3/8 flat washer (24)
E.Leveling foot with jam nut (4)
F.Lathe stand platforms (2)
G.Cross brace / tool holder
H.Stand leg assemblies (2)
ASSEMBLY
NOTE: For ease of alignment, do not fully tighten bolts and nuts until assembly is complete.
1. | Make sure jam nut (I) Fig. 3 (inset) is on the four rubber leveling |
| feet as shown. |
2. | Screw in four rubber leveling feet (E) Fig. 3 into stand leg |
| assemblies. Tighten all the way down. Height can be adjusted |
| later. |
3. | Attach left leg assembly (H) Fig. 4 and 5 to cross brace/tool holder |
| (G) oriented as shown using two |
| bolts (C) Fig. 4, two 3/8 flat washers (not shown) and two |
| nylock nuts (A) Fig. 4 in top and bottom holes only. A bolt is not |
| required in the center hole. Make sure the stand's feet are oriented |
| away from tool holder (G) as shown in Fig. 5. |
4. | For both holes, place washer (not shown) on bolt and insert hex |
C
B
A
D
E | Fig. 1 |
|
F
H
G
Fig. 2
I
head bolt (C) Figure 4 into the leg from the outside and then through |
the hole in the tool holder. Place a second washer (not shown) on |
bolt and fasten with the nylock nut (A). |
Fig. 3
E
C
A |
| A |
H |
G
Fig. 4
H
G
Fig. 5
1