slightly, then clockwise, to engage the lead thread into the Jaw (B and C in Figure 16).
e. Slide Jaw #2 into the next groove and continue turning the Chuck Key clockwise to advance the lead thread into the next Jaw. Slide Jaw #3 with the same procedure as Jaw #2.
Note: When mounting a workpiece, it is recommended that all three jaws are loosened at the same time. This will protect the threads inside.
Compound Rest Adjustment
Compound Rest Crank (86b)
Compound Rest B (105)
Bolt Holes
& Bolts (67)
Compound Rest A (108)
Tailstock Adjustments
The Tailstock (138) holds tools, such as the Live Center (143), which are used with the Chuck Jaws (167 or 168) to hold work pieces in place.
Tailstock | Tailstock Quill Fix | Tailstock |
Quill (142) | Holder (146) | |
Live Center |
| (138) |
(143) |
|
|
Underside |
|
|
of |
|
|
Tailstock |
| Tailstock |
|
| Quill |
Nut (6) | Tailstock | Control |
| Wheel | |
Screw (197) | Nut | (84a) |
| (268) |
|
Figure 18
1.Use the Tailstock Quill Control Wheel (84a) to position the Live Center. Turning the Wheel counterclockwise slides
the Live Center away from the Chuck, turning it clockwise slides it toward the Chuck. It can be adjusted up to approximately 2”.
Figure 17
To adjust the angle of Compound Rest:
a. Turn the Compound Rest Crank (86b) counterclockwise to slide the top section of the Compound Rest (Compound Rest A (108)) so that the two screw holes are exposed on the lower section of the Compound Rest (Compound Rest B (105)).
b. Turn the two Bolts (67) counterclockwise to loosen them.
c. Swivel the Compound Rest to the desired angle.
d. Tighten the two Screws.
REV 10b
2.The Tailstock Quill (142) holds the Live Center in place. To remove or replace the Live Center, continue turning the Tailstock Quill Control Wheel counterclockwise until the Live Center begins to slide out of the Quill. Insert the Live Center or other tool (sold separately) into the Quill and turn the Tailstock Quill Control Wheel clockwise to lock the tool in place.
3.You may need to slide the Tailstock closer to, or further away from, the Chuck before adjusting the Live Center. To do so, loosen the Tailstock Nut (268), adjust the Tailstock as needed, then re- tighten the Nut. Use this method when replacing the Tailstock as well.
SKU 93212 | For technical questions, please call | Page 17 |