4.The Tailstock Quill is locked in place with the Tailstock Quill Fix Holder (146). Turn it clockwise to lock the Quill in place and counterclockwise to loosen it. Tighten the Nut (6) underneath the Quill to eliminate any play in the Quill.
5.To adjust the Tailstock slightly to the right or left of center, loosen the Screw (197) on the bottom of the Tailstock. Adjust, then tighten.
Tool Post Adjustment
Tool Post Lever (111)
Tool Post (112)
Tool Post Bolt (110)
Cutter (Sold separately)
Figure 19
To adjust the position of the Tool Post (112):
a. Turn the Tool Post Lever (111) counterclockwise to loosen the Tool Post.
b. Rotate the Tool Post as needed.
c.Hold the Tool Post in position while turning the Tool Post Lever clockwise, tightening the Tool Post in place.
To install a cutting tool (Sold separately):
a. Use the 1/4” Hex Wrench (part of 311) to raise enough Tool Post Bolts (110) to hold the tool. Use at least two Tool Post Bolts to hold the tool in place (Turn counterclockwise to raise).
b. Slide the tool under the raised screws and hold it while lowering the screws
until they are securely holding the tool in place.
Automatic Feeding
Feed Control
Wheel (84b)
OFF
ON
Automatic Feel Lever (79)
Figure 20
The Automatic Feed Lever (79) controls whether the Carriage (93) moves automatically, or manually.
When the Lever is Up, the Lathe is in Manual mode. Use the Feed Control Wheel (84b) to slide the Carriage to the right or left.
When the Lever is Down, the Lathe is in automatic mode. The carriage will automatically move to the right or left depending on whether it is set to forward or reverse.
Note: The Feed Control Wheel (84b) is locked when the automatic feed is ON.
REV 10b
Page 18 | For technical questions, please call | SKU 93212 |