Harbor Freight Tools 65345 See Figure M, To Install And Remove The Cup Center, See Figure N, next

3.NOTE: If the Lathe is used with the Faceplate (13) removed, a knockout tool (not included) is required for removing the Headstock Spur Center (12). (See Figure L.)

HEADSTOCK

SPINDLE

(14)

FACEPLATE

(13)

The Lock Lever

(6) must always be

locked down while the Lathe is in use. The workpiece can be thrown from the Lathe if this step is not followed. The Tail Axis

(8)should not protrude from the Tailstock

(5)more than 2” or the Tail Axis will not be supported enough. Failure to follow these warnings may result in personal injury.

(See Figure M.)

2.Rotate the Tailstock Handwheel (4) clockwise until the Tail Axis (8) pro- trudes out of the Tailstock (5) about 3/4”. (See Figure M.)

3.Insert the Cup Center (11) and push firmly. Then retighten the Lock Lever

(6).(See Figure M.)

4.To remove, loosen the Lock Lever

(6)approximately half a turn counter- clockwise. (See Figure M.)

5.Rotate the Tailstock Handwheel (4) counterclockwise until the Tail Axis

(8)bottoms out, causing the Cup Center (11) to be forced out of the Tail Axis. (See Figure M.)

To Install And Remove The Faceplate:

1.To install, thread the Faceplate (13) onto the Headstock Spindle (14) until it is secure against the shoulder on the Headstock Spindle.

(See Figure N, next page.)

2.To remove, hold the Balance Wheel (22) securely while turning the Face- plate (13) counterclockwise until it is removed. If the Headstock Spur Cen- ter (12) is installed, it will be removed during this process.

(See Figure N, next page.)