Quill | Quill Lock Handle |
| |
| Quill |
| Handwheel |
Live Center | |
Figure 17. Installing live center in tailstock.
4.Tighten the quill lock handle.
To remove the live center:
1.Loosen the quill lock handle (if locked) approximately half a turn counterclockwise.
2.Turn the quill handwheel counterclockwise until the tailstock quill bottoms out, causing the live center to be forced out of the quill.
The tailstock quill lock handle must always be locked down while the lathe is in use. The workpiece can be thrown from the lathe if this step is not observed. Also, the tailstock quill should not protrude from the tailstock housing more than 2'' or the quill will not be supported enough. Failure to follow these warnings may result in personal injury.
Removing/Installing
Faceplate
To remove faceplate:
1.UNPLUG LATHE FROM POWER!
2.Hold the headstock spindle wheel securely while turning the faceplate counterclockwise until it is removed. If the spur center is installed, it will be removed during this pro- cess.
Faceplate |
Headstock |
Spindle wheel |
Figure 18. Removing faceplate.
To install faceplate:
1.UNPLUG LATHE FROM POWER!
2.Thread faceplate onto spindle shaft until it is secure against the shoulder on the spindle shaft.
To mount a workpiece to your faceplate, refer to Page 20.
H8259 10" x 18" Benchtop Lathe |