Grizzly H8259 Adjusting Tailstock Adjusting Tool Rest, To position the tailstock along the bed

Page 17
-15-

Adjusting Tailstock

 

Adjusting Tool Rest

 

 

 

 

 

 

The tailstock is equipped with a cam-action clamping system to secure it to the lathe bed. When the lever is tightened, a locking plate lifts and secures the tailstock to the bed.

To position the tailstock along the bed:

1.Loosen the release lever and move the tailstock to the desired position (Figure 13).

The tool rest base is equipped with a cam-action clamping system to secure it to the lathe bed. When the lever is engaged, a locking plate lifts up and secures the tool rest base to the bed.

To position the tool rest base along the bed:

1.Loosen the release lever and slide the tool rest base along the bed (Figure 14).

Lathe Bed

Release

Lever

Figure 13. Tailstock controls.

2.Re-engage the release lever.

3.If the release lever will not lock or release the tailstock (either too loose or too tight), loosen or tighten the tailstock mounting nut (located on the underside of the tailstock) in small increments as needed to achieve the proper clamping pressure.

H8259 10" x 18" Benchtop Lathe

Lock Handle

Tool Rest

Base

 

 

Release

Lathe Bed

 

 

Lever

 

 

 

 

 

 

 

Figure 14. Tool rest controls.

2.Re-engage the release lever to lock the tool rest base in place.

—If the release lever will not lock or release(either too loose or too tight), then loosen or tighten the tool rest base mount- ing nut (located on the underside of the tool rest base) in small increments as needed to achieve the proper clamping pressure.

To adjust the tool rest:

1.Loosen the lock handle (Figure 14) and adjust the tool rest vertically or swivel it as needed, then tighten the lock handle.

Image 17
Contents Model H8259 Page Table of Contents Contact Info IntroductionForeword H8259 10 x 18 Benchtop Lathe H8259 10 x 18 Benchtop Lathe Identification H8259 10 x 18 Benchtop Lathe H8259 10 x 18 Benchtop Lathe Additional Safety for Wood Lathes 110V Operation Circuit RequirementsSet Up Safety Unpacking SetupBox Contents Figure Qty InventoryG7895-Grizzly Citrus Degreaser Clean UpSite Considerations To test run the machine Assembly Test RunTo assemble the lathe Operations Operation SafetyChanging Speeds To change speedsOpen the side and rear access covers Figure To adjust the tool rest Adjusting Tailstock Adjusting Tool RestTo position the tailstock along the bed To position the tool rest base along the bedInstalling/Removing Live Center Installing/Removing Spur CenterTo install the spur center To install the live centerTo install faceplate Removing/Installing FaceplateTo remove the live center To remove faceplateGouge Selecting Turning ToolsSpindle Turning To set up a spindle turning operationTo mount your workpiece to the faceplate Faceplate TurningTo mount your workpiece to a backing block Sanding/FinishingG1194-3-Jaw Chuck AccessoriesH7828-Tool Table Plus G1082-4-Jaw ChuckCleaning MaintenanceSchedule Unpainted Cast IronTo remove the old belt To install new beltChanging Belt Troubleshooting ServiceSymptom Possible Cause Possible Solution Motor connections H8259 10 x 18 Benchtop Lathe H8259 Wiring DiagramMain Breakdown Description Main Breakdown Parts List101 103 104 102 105 106 Page Page Warranty and Returns