Grizzly H8259 owner manual Installing/Removing Spur Center, Installing/Removing Live Center

Page 18

Installing/Removing

Spur Center

The spur center installs into the headstock spin- dle with a taper fit.

To install the spur center:

1.UNPLUG LATHE FROM POWER!

2.Insert the tapered end of the center into the spindle, and push it in quickly and firmly (Figure 15).

Headstock

 

Spindle Wheel

Spur Center

 

Figure 15. Inserting spur center into spindle.

3.Check that the center is securely installed by giving it a quick tug. (A properly installed center will not pull out by hand.)

To remove the spur center:

1.UNPLUG LATHE FROM POWER!

2.Hold the headstock spindle wheel securely while turning the faceplate counterclockwise until the spur center is forced out of the head- stock spindle (Figure 16).

 

Faceplate

Headstock

 

Spindle Wheel

Spur Center

 

Figure 16. Removing spur center.

Note: If the lathe is used with the faceplate removed, a knockout tool (not included) is required for removing the spur center.

Installing/Removing

Live Center

To install the live center:

1.Loosen the quill lock handle (if locked) approximately half a turn counterclockwise.

2.Rotate the quill handwheel clockwise until the tailstock quill protrudes out of the tailstock housing about 34''.

3.Insert the live center, as shown in Figure 17, and push firmly.

-16-

H8259 10" x 18" Benchtop Lathe

Image 18
Contents Model H8259 Page Table of Contents Introduction ForewordContact Info H8259 10 x 18 Benchtop Lathe H8259 10 x 18 Benchtop Lathe Identification H8259 10 x 18 Benchtop Lathe H8259 10 x 18 Benchtop Lathe Additional Safety for Wood Lathes Circuit Requirements 110V OperationBox Contents Figure Qty SetupSet Up Safety Unpacking InventoryClean Up Site ConsiderationsG7895-Grizzly Citrus Degreaser Assembly Test Run To assemble the latheTo test run the machine Changing Speeds Operation SafetyOperations To change speedsOpen the side and rear access covers Figure To position the tailstock along the bed Adjusting Tailstock Adjusting Tool RestTo adjust the tool rest To position the tool rest base along the bedTo install the spur center Installing/Removing Spur CenterInstalling/Removing Live Center To install the live centerTo remove the live center Removing/Installing FaceplateTo install faceplate To remove faceplateSelecting Turning Tools GougeTo set up a spindle turning operation Spindle TurningFaceplate Turning To mount your workpiece to the faceplateSanding/Finishing To mount your workpiece to a backing blockH7828-Tool Table Plus AccessoriesG1194-3-Jaw Chuck G1082-4-Jaw ChuckSchedule MaintenanceCleaning Unpainted Cast IronTo install new belt Changing BeltTo remove the old belt Service TroubleshootingSymptom Possible Cause Possible Solution H8259 Wiring Diagram Motor connections H8259 10 x 18 Benchtop LatheMain Breakdown Main Breakdown Parts List Description101 103 104 102 105 106 Page Page Warranty and Returns