Assembly
1.Place the base (A, Fig. 1) on a level floor.
2.With a 17mm wrench attach the column assembly (B, Fig. 1) to the base (A, Fig. 1) with four M10 x 40 hex cap bolts (C, Fig. 1). Tighten firmly.
3.Thread lock handle (D, Fig. 2) into the table bracket (E, Fig. 2).
4.Loosen the set screw (F, Fig. 3) on the raising handle (G, Fig. 3) with a 3mm hex wrench.
5.Slide the handle onto the table bracket shaft.
6.Turn the handle until the set screw is opposite the flat section on the shaft, and tighten the set screw to secure the handle.
7.Insert the table (H, Fig. 3) into the table bracket.
8.Tighten the table lock handle (I, Fig. 3).
10