Jet Tools JDP-17FSE owner manual Adjusting the Depth Stop, Changing Spindle Speeds

Page 12

Adjusting the Depth Stop

To drill multiple holes at the same preset depth, use the depth stop:

1.Lower the bit until it touches the workpiece.

2.Loosen lock knob (A, Fig. 7) and rotate housing (B, Fig. 7) until the pointer lines up with the depth you want to drill, indicated by the scale.

3.Tighten lock knob.

4.The drill bit will now advance to this depth.

Changing Spindle Speeds

A spindle speed and belt arrangement chart are found on the inside of the belt cover, see Figure

8.Refer to this chart whenever changing speeds.

To change spindle speeds:

1.Unplug the machine from the power source.

2.Loosen two bar knobs (C, Fig. 9) found on each side of the head assembly.

3.Rotate the tension adjuster (D, Fig. 9) to bring the motor base as close to the head as possible.

4.Change the belts location according the speed chart and the speed you desire.

5.Rotate the tension adjuster (D. Fig. 9) to tension the belts.

6.Tighten two bar knobs (C, Fig. 9). Belts are properly tensioned when finger and thumb pressure midway between the two pulleys causes approximately ½” deflection.

12

Image 12
Contents JDP-17FSE JET Drill Press Warranty & Service Total Length of Cord in Feet AWGPage Grounding Instructions Volt OperationDisconnect the machine from the power source On-Off Switch Padlock Model No. BP-1, Stock NoSpecifications Table of ContentsContents of the Shipping Container Tools Supplied for AssemblyTools Required for Assembly Assembly Unplug machine from the power source Removing the Chuck and ArborAdjusting the Depth Stop Unplug the machine from the power sourceChanging Spindle Speeds Speed & Pulley Chart Return Spring Adjustment Table Tilt AdjustmentBasic Operation LubricationTroubleshooting Parts Breakdown for JDP-17FSE Parts List for JET JDP-17FSE Drill Press Index Part Description Size Qty10705703