Return Spring Adjustment, Work Light | Jet Tools JDP-20MF specification

Return Spring Adjustment

The return spring is adjusted at the factory and should not need further adjustment. If adjustment is deemed necessary, follow the steps below while referring to Figure 12:

1.Unplug the machine from the power source.

2.Loosen two hex nuts (A). Do not remove.

Do not remove the coil spring cover (Step 3). The torsion spring will uncoil and can cause serious injury.

3.Firmly hold the coil spring cover (B).

4.Pull out the cover and rotate until the pin (C) on the return spring plate engages the next notch in the coil spring cover. Turn the cover clockwise to decrease tension and counter- clockwise to increase tension.

5.Tighten two hex nuts (A). Do not over-tighten. Nuts should not contact the housing when tight. The hex nuts should be tightened against each other.

Work Light

Install a light bulb, no larger than 60 watts into the socket accessed from beneath the head. The rocker switch controls the light switch (D, Fig. 12).

Table Tilt Adjustment

To tilt the table (refer to Figures 13 and 14):

In the following steps, DO NOT OVER LOOSEN. This could result in the table assembly to separate from the column, fall and cause injury.

1.Using a 15/16" wrench, loosen the hex cap screw (B), located under the table, about one turn.

2.Pull the locator pin out.

The pin may be seated quite tight; in which case turn the hex nut (B) clockwise with a 3mm hex wrench to assist in extracting the pin

Note: When the table is in any position other than level (0 degrees), the locator pin is not used.

3.Tilt the table to the desired angle by aligning the scale (in degrees) on the table (C) to the marker at the base of the bracket (D).

4.Tighten the hex cap screw (A).

Figure 12

Figure 13

Figure 14

JDP-20MF specifications

The Jet Tools JDP-20MF is a powerful and versatile drill press designed to meet the needs of both professional woodworkers and DIY enthusiasts. Known for its impressive features, robust build, and advanced technology, this drill press provides users with precision and reliability for various woodworking tasks.

One of the standout features of the JDP-20MF is its heavy-duty 1 HP motor. This powerful motor ensures consistent performance, capable of handling a wide range of materials from softwoods to hardwoods with ease. With a variable speed control that ranges from 140 to 3000 RPM, users can easily adjust the speed according to the material and drilling requirements, ensuring optimal results for each application.

The JDP-20MF comes equipped with a 20-inch swing, which allows users to drill holes in larger workpieces without the need for repositioning. Its substantial table measures 12-1/2 inches by 24 inches, providing ample support and stability for large pieces. The table is also adjustable, tilting up to 30 degrees left and right, catering to a variety of drilling angles and tasks.

Another notable technology integrated into the JDP-20MF is the laser guide system. This feature projects a laser beam onto the workpiece, ensuring precise alignment and accurate drilling. This not only increases efficiency but also reduces the likelihood of costly mistakes, making it an invaluable tool for meticulous woodworkers.

Safety is paramount in the design of the JDP-20MF, as evidenced by its built-in safety key, which prevents accidental start-ups, and its sturdy metal housing that minimizes vibrations during operation. The drill press also features a work light to illuminate the drilling area, enhancing visibility and precision.

In summary, the Jet Tools JDP-20MF is a robust and feature-rich drill press that excels in both performance and versatility. With its powerful motor, variable speed settings, generous swing and table size, laser guide system, and focus on safety, it is an excellent choice for anyone looking to elevate their woodworking projects. Whether for a professional workshop or a home garage, the JDP-20MF stands out as a reliable and efficient drilling solution.