GB - ENGLISH
Operating Instructions
Dear Customer,
Many thanks for the confidence you have shown in us with the purchase of your new
…Table of Contents
1.Declaration of conformity
2.Warranty
3.Safety
Authorized use
General safety notes
Remaining hazards
4.Machine specifications Technical data
Noise emission Contents of delivery Description of machine
5.Transport and start up Transport and installation Assembly
Dust connection Mains connection Starting operation
6.Machine operation
7.Setup and adjustments Changing saw blade Mounting the raving knife Mounting the saw guard Rising and tilting sawblade Rip fence setup Adjusting 90°stop Adjusting sawblade parallel
8.Maintenance and inspection
9.Troubleshooting
10.Environmental protection
11.Available accessories
12.„Safe operation”........ appendix A
1. Declaration of conformity
On our own responsibility we hereby declare that this product complies with the regulations* listed on page
2.Designed in consideration with the standards**. CE type examination*** performed by****.
2. Warranty
The Seller guarantees that the supplied product is free from material defects and manufacturing faults. This warranty does not cover any defects which are caused, either directly or indirectly, by incorrect use, carelessness, accidental damage, repair, inadequate maintenance or cleaning and normal wear and tear.
Guarantee and/or warranty claims must be made within twelve months from the date of purchase (date of invoice). Any further claims shall be excluded.
This warranty includes all guarantee obligations of the Seller and replaces all previous declarations and agreements concerning warranties.
The warranty period is valid for eight hours of daily use. If this is exceeded, the warranty period shall be reduced in proportion to the excess use, but to no less than three months.
Returning rejected goods requires the prior express consent of the Seller and is at the Buyer’s risk and expense.
Further warranty details can be found in the General Terms and Conditions (GTC). The GTC can be viewed at www.jettools.com or can be sent by post upon request.
The Seller reserves the right to make changes to the product and accessories at any time.
3. Safety
3.1 Authorized use
This machine is designed for sawing wood, wood derived materials as well as similar to be machined hard plastics only.
Machining of other materials is not permitted and may be carried out in specific cases only after consulting with the manufacturer.
No metal workpieces may be machined.
The workpiece must allow to safely be loaded, supported and guided.
Do not cut round stock without suitable jigs or fixtures. The rotating saw blade could turn the
The proper use also includes compliance with the operating and maintenance instructions given in this manual.
The machine must be operated only by persons familiar with its operation, maintenance and repair and who are familiar with its hazards. The required minimum age must be observed
The machine must only be used in a technically perfect condition When working on the machine, all safety mechanisms and covers must be mounted.
In addition to the safety requirements contained in this operating instructions and your country’s applicable regulations, you should observe the generally recognized technical rules concerning the operation of woodworking machines.
Any other use exceeds authorization. In the event of unauthorized use of the machine, the manufacturer renounces all liability and the responsibility is transferred exclusively to the operator.
3.2 General safety notes
Woodworking machines can be dangerous if not used properly. Therefore the appropriate general technical rules as well as the following notes must be observed.
Read and understand the entire instruction manual before attempting assembly or operation.
Keep this operating instruction close by the machine, protected from dirt and humidity, and pass it over to the new owner if you part with the tool.
No changes to the machine may be made.
Daily inspect the function and
3