Jet Tools JTS-315SP Requirements for machine assembly, Stand assembly, Install dust port

immediately. Do not operate the machine!

Dispose of the packing in an environmentally friendly manner.

Clean all rust protected surfaces with a mild solvent.

Requirements for machine assembly:

-Philips screwdriver -22mm wrench -17mm wrench -10mm wrench -8mm wrench -pair of work gloves

Stand assembly:

The four legs have been folded before shipment.

To assemble the stand:

-unfold the four legs ( J, Fig 2) and tighten the nuts securely.

-insert the short crossbeams and tighten the nuts.

Fig 2

-insert the short crossbeams (Fig 3) and tighten the nuts

Fig 4

Install dust port:

Attach the dust port with 3 taping screws (M, Fig 5).

Fig 5

Install switch:

Fit the switch (C, Fig 6) on the left front leg, using two M4 self-locking nuts and two M4X60 screws.

Install rip fence:

Use 2 bots and wing nuts (W, Fig 7) to attach the aluminium profile

(G) to the rip fence body

Fig 7

Install rear extension table:

Fit the rear table extension (X, Fig 8).

Fig 8

Fig 3

NOTE: The carriage bolts (L, Fig 4) must be positioned in the groove to fasten through wing nut.

Fig 6

Install saw blade:

See chapter 7.1

Install raving knife:

See chapter 7.2

Install table insert:

Position the table insert into the Table top, and lock with 6 screws.

Install blade guard:

See chapter 7.3

Install rip fence carrier:

Attach the rip fence carrier to the machine table front with

-2 Carriage bolts M6X20 - 2 Nuts M6

6

Fig 9

Attach two support arms (Y, Fig 10). Adjust the table to be level and tighten the nuts.