Fig 20
Start the machine with care.
7.6 Adjusting 90°stop
The positive stop is adjusted at the factory.
If out of alignment:
Disconnect saw from the power source, unplug.
Readjust the positive 90° stop.
7.7 Adjusting sawblade parallel
The sawblade is adjusted parallel to the machine table at the factory.
If out of alignment:
Disconnect saw from the power source, unplug.
Loosen the screws on the tabletop (V, Fig 21) and readjust saw unit.
Fig 21
8. Maintenance and inspection
General notes:
Maintenance, cleaning and repair work may only be carried out after the machine is protected against accidental starting by pulling the mains plug.
Repair and maintenance work on the electrical system may only be carried out by a qualified electrician.
Consult a qualified repair shop if a malfunction or damage occurs to this tool, including sawblades and guards.
Cleaning:
Clean the machine regularly.
Inspect the proper function of the dust extraction daily.
Keep the inside of the cabinet clear of sawdust and wood chips.
All protective and safety devices must be
Defective safety devices must be replaced immediately.
Saw blades:
The servicing of saw blades should only be performed by a trained person.
Defective safety devices must be replaced immediately.
Check saw blades regularly for faults. Replace a defective sawblades immediately.
Motor Break:
The motor break works electro- mechanically (break motor).
If breaking time should exceed 10 seconds, the motor break assembly needs to be replaced. Contact your Jet service station immediately.
9. Trouble shooting
Motor doesn’t start *No electricity-
check mains and fuse.
*Defective switch, motor or cord- consult an electrician.
Machine vibrates excessively
*Stand on uneven floor- adjust stand for even support.
*dust on saw flanges-
clean saw arbor and flanges.
*defective sawblade -
replace sawblade immediately
Cut is not accurately square *90° stop not adjusted correctly- check with square and adjust stop.
Material binds blade when ripping
*Rip fence not parallel to sawblade- check and adjust rip fence.
*Wrapped wood-
select another piece of wood.
*Excessive feedrate- reduce feedrate.
Material kicked back from blade
*Fence not aligned with sawblade- check and adjust rip fence.
9
*Raving knife not in place-
high danger, mount immediately with guard.
Cutting surfaces is bad *Wrong sawblade used *Blade mounted backwards *resin collection on sawblade *sawblade is dull
*work piece inhomogeneous *Feed pressure too high- Do not force the work piece.
10. Environmental protection
Protect the environment.
Your appliance contains valuable materials which can be recovered or recycled. Please leave it at a specialized institution.
11. Available accessories
(A, Fig 22) Stock No.: 10000811 Right table extension 550 x 800mm including rip fence base extension.
Fig 22
Fig 23
Refer to the
12. Safe operation
See appendix A (on the last pages of this operating manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on rip fence
A.4.: Mitre cutting
A.5.: Ripping of big board