operating manual)
(on the last pages of this operating manual)
A.1.: Ripping
A.2.: Ripping of narrow stock
A.3.: Crosscutting on rip fence
A.4.: Mitre cutting
A.5.: Ripping of big board
7.Setup and adjustments General note:
Setup and adjustment work may only be carried out after the machine is protected against accidental starting by pulling the mains plug.
7.1 Changing sawblade
The sawblade has to meet the technical specification.
Use only sawblades according to EN 847-1
Check sawblade for flaws (cracks, broken teeth, bending) before installation. Do not use faulty sawblades.
The sawblade teeth must point in cutting direction (down)
Always wear suitable gloves when handling sawblades.
WARNING:
When installing or changing saw blade, always disconnect saw from power source, unplug!
Remove the saw guard (A, Fig 1)) and table insert (B).
Raise sawblade fully.
Loosen the arbor nut while stopping the arbor against rotation with the supplied tools (S, T, Fig 15)
Fig 15
Attention: left hand thread.
Remove the arbor nut (R, Fig 16 and flange (Q).
Fig 16
Place saw blade(P) on arbor shaft making sure teeth point down at the front of the saw.
Reinstall flange and arbor nut and securely tighten.
Order for installation:
Reinstall the table insert and the saw guard.
7.2 Mounting the raving knife
The supplied raving knife must always be used.
Disconnect saw from power source, unplug!
The raving knife (F, Fig 17) is clamped with 1 nut (U).
Fig 17
Adjust the space between sawblade teeth and raving knife to be 2 to 5mm.
Well tighten the locking nut (U).
7.3 Mounting the saw guard
The saw guard must always be used.
Attach the saw guard (A, Fig 18) to the raving knife (F) with 1 carriage bolt, washer and wing nut
8
Fig 18
The saw guard must be lowered to the work piece to minimise the amount of exposed teeth.
7.4 Rising and tilting of sawblade
Setup adjustments of the sawblade shall never be performed when the machine is running.
Use the front handle (I, Fig 1)to raise the sawblade.
Use the tilting handle (H, Fig 1) to tilt the sawblade. Tighten knob to lock in place.
Start the machine with care.
7.5 Rip fence setup
Rip fence setup shall never be performed when the machine is running.
Use 2 bots and wing nuts (W, Fig 19) to attach the aluminium profile (G) to the rip fence body
Fig 19
Note:
The rip fence profile can be placed flat and adjusted in length.