Maintenance
Before doing maintenance on the machine, disconnect it from the electrical supply by pulling out the plug or switching off the main switch! Failure to comply may cause serious injury.
Use a brush to loosen accumulated chips and debris. Use a shop vacuum to remove the debris. Make sure the chip brush on the lower band wheel is properly adjusted.
Lubricate the air compressor with air tool oil about every six months, or more frequently if necessary. Unscrew the cap (Figure 26) and add oil. Replace cap when finished.
Add grease to the gear box through the grease fitting; also add grease as needed to the worm gear.
If the power cord is worn, cut, or damaged in any way, have it replaced immediately.
Figure 26
The chart (Figure 27) identifies areas that require cleaning and/or lubricating. Use good quality, general purpose lubricants.
Machine Part | Lubricant | Frequency |
|
|
|
Bearings | Machine oil | Wipe down every day and |
|
| lubricate every 6 months |
|
|
|
Rack and sliding portion of | Grease | every 7 days |
Guide Post |
|
|
|
|
|
Gear shift lever | Grease | every 6 months |
|
|
|
Worm gear | Grease | every 3 months |
|
|
|
Variator pulley | Machine oil | every 3 months |
|
|
|
Blade tension screw | Grease | once a month |
|
|
|
Air compressor reservoir | Air Tool oil | every 6 months |
|
|
|
Weld clamp jaws | clean after each use | |
|
|
|
Rubber tire | wipe off daily | |
|
|
|
Work tables | clean daily | |
|
|
|
Figure 27
22