Jet Tools VBS-3612 operating instructions Introduction Specifications

Page 6

Introduction

This manual is provided by WMH Tool Group covering the safe operation and maintenance procedures for a JET Model VBS-3612 Band Saw. This manual contains instructions on installation, safety precautions, general operating procedures, maintenance instructions and parts breakdown. This machine has been designed and constructed to provide years of trouble free operation if used in accordance with instructions set forth in this manual. If there are any questions or comments, please contact either your local supplier or WMH Tool Group. WMH Tool Group can also be reached at our web site: www.wmhtoolgroup.com.

Specifications

 

Model Number

VBS-3612

Stock Number

414470

Blade Speeds (SFPM)

Low 50-410; High 540-4925

Height Capacity, Maximum (in.)

12

Throat Capacity, Maximum (in.)

36

Table Size, Main (L x W)(in.)

23-5/8 x 27-1/2

Table Size, Auxiliary (L x W)(in.)

17-3/4 x 27-1/2

Table Height at 90° (in.)

40

Table Tilt (deg.)

10° L, 45° R

Welder (KVA)

4.2

Blade Length, approx. (in.)

195-1/4198-1/4

Blade Width (in.)

1/8 min., 1/2 max.

Motor

3HP, 3Ph, 230/460V (prewired 230V), 60Hz

Floor Space Required (in.)

69 x 32

Net Weight (lbs.)

1,760

The above specifications were current at the time this manual was published, but because of our policy of continuous improvement, WMH Tool Group reserves the right to change specifications at any time and without prior notice, without incurring obligations.

6

Image 6
Contents Inch Metalworking Band Saw Warranty and Service More InformationTable of Contents Page Page Introduction Specifications Features and Terminology Contents of the Shipping Container UnpackingFeed Screw Installation and AssemblyFence ShearVolt, Three Phase Operation Grounding InstructionsExtension cords Three-Phase Test Run AdjustmentsConverting from 230 Volt to 460 Volt Three Phase Blade Removal and InstallationBlade Tension Blade TrackingGuide Post Blade GuidesSquaring Work Table with Blade Auxiliary TableReplacing Drive Belts Band Saw Operation Blade Break-In ProcedureSetting Blade Speed Work Lamp BulbWelder Operation Evaluating Cutting EfficiencyShearing Removing Teeth WeldingAnnealing Blade Selection WidthGage PitchShape Set MaterialBlade Breakage Maintenance Machine Part Lubricant FrequencySpeed and Pitch Chart Typical Band Saw Operations Troubleshooting Operating Problems Troubleshooting Mechanical and Electrical Problems Trouble Probable Cause Remedy Troubleshooting Welded Blade Inspection Troubleshooting Welder Mechanical Problems Replacement PartsIndex No. Part No Description Size Qty TS-0561021 TS-0051051 VBS3612-1174 TS-0267061 VBS-3612 Band Saw VBS-3612 Band Saw JWG34-601 PR-EV-6280 Welder, Shear and Work Lamp Assemblies Electrical Connections 3Ph, 230/460V SB1 Electrical Box Page WMH Tool Group