Figure 11
6.10Clamping Pressure
The XACTA Fence has been adjusted by the manufacturer to lock securely when lock handle is pushed down. If adjustment is needed:
1.Unlock fence.
2.Remove fence from guide tube and turn it over.
3.Adjust each of two setscrews (A, Figure 11) exactly the same number of rotations until the fence is held securely when lock handle is pushed down.
6.11Checking 90° to Table
1.Place fence on saw table and lock it.
2.Place a square (A, Figure 12) on table next to fence. The fence should be 90° to the table.
3.If adjustment is necessary, unlock fence and turn one of two nylon adjustment screws (B, Figure 12) until fence is 90° to table.
4.Lock fence and check the adjustment again.
Figure 12
6.12Cursor Adjustment
1.Disconnect saw from power source.
2.Raise blade above table top.
3.Unlock fence and slide it to approximately four inches from blade.
4.Lock the fence.
5.Measure distance between saw blade and inside of fence.
6.Adjust cursor (C, Figure 12) to read the distance just measured, and tighten cursor assembly to fence.
7.Make a test cut and confirm the adjustment is correct.
Note: If the cursor does not have enough travel to give the correct measurement, loosen guide rail and adjust as needed. If you still do not get the correct measurement, loosen front rail and adjust as needed. If you have to adjust front rail you will need to go through the front rail assembly instructions again.
Cursor accuracy should be checked whenever a different blade is installed.
After installing the XACTA Fence, press the black plastic end covers into the openings of the guide rail. There is also an end cover for the fence that may already be installed.
10