Jet Tools M-708955Z manual Setup and assembly, Tools required, Shipping contents

6.0Setup and assembly

Open shipping cartons and check that all parts are intact. Report any damage immediately to your distributor. Read the instruction manual thoroughly for assembly, alignment, and maintenance instructions.

6.1Tools required

1#3 cross point screwdriver

17/16” wrench

11/2" wrench

1Combination square & straight edge

11/4” hex key

13/16” hex key

6.2Shipping contents

1XACTA Fence II

1Front rail

1Back rail

1Guide tube

3Black plastic end covers

1Owner’s manual

1Warranty registration card

1Hardware package (p/n XF12DX-HP)* contains:

7 Flat head screws, 1/4 x 1-1/2 (HP-1)5 Hex cap screws, 1/4 x 1-1/2 (HP-2)7 Hex cap screws, 1/4 x 3/4 (HP-3)

2 Hex cap screws, 5/16 x 3/4 (HP-4)2 Flat washers, 5/16 (HP-5)

24 Flat washers, 1/4 (HP-6)

19 Lock washers 1/4 (HP-7)

12 Hex nuts 1/4 (HP-8)

*Hardware package is shipped inside guide tube. Contents are shown full scale in Figure 1.

6.3Front rail installation

1.Identify the front rail (A, Figure 2), which is 2-1/2" x 2-1/2" with notches on one side and countersunk mounting holes on the other side.

2.Lightly secure front rail (A) to table with seven 1/4 x 1-1/2 screws, flat washers, lock washers and hex nuts (HP-1/6/7/8).Tighten just enough to hold rail next to table but loose enough to allow height adjustment.

Figure 1

Figure 2

7