Figure 6
6.7XACTA Fence
Screw knob into threaded handle on fence, as shown in Figure 7.
Figure 7
The lock lever has three functional positions as shown in Figure 8:
Figure 8
1.Upright position permits mounting and removal of fence from saw.
2.Unlock position permits easy fence positioning.
3.Lower position locks fence to guide tube. The cam handle should be pushed down firmly against the pin.
6.8Leveling fence to saw table
Place fence on table and lock it.
1.View the fence from left side of saw (Figure 9). Look for the space between the table and the fence bottom to be equal along entire length of fence (A, B, Figure 9).
Figure 9
If adjustment is necessary:
2.Unlock fence.
3.Raise or lower two nylon adjustment screws (D, Figure 10) the same number of turns until the space between bottom of fence and table is the same. Care must be taken to raise or lower fence on each side equally or the fence may not be 90° to the table after the height adjustment is performed.
Figure 10
6.9Adjusting fence parallel to miter slot
1.Place fence next to outside edge of right miter slot and lock it.
2.Fence should be even with miter slot from front to back.
3.If fence is not even along length of miter slot, unlock fence, remove it and turn it upside down.
4.Adjust one of two setscrews (A, Figure 11) until fence is even with miter slot edge along its entire length when locked.
Note: You may need to
9